Electronics Forum | Fri Aug 16 15:47:56 EDT 2013 | larrygroves
Hi, I know it's confusing. The 421 is sold with two different vision cameras, standard and megapixel. It depends where you buy the machine. North american machines come with the megapixel cameras standard and will just need a Cn020 nozzle and app
Electronics Forum | Fri Aug 16 09:35:54 EDT 2013 | leemeyer
I am doing some research on Pick and Place machines and have found the Samsung brochure a bit confusing. Specifically I am looking at the SM421, some of the information I am finding states that this machine is spec'd to place 0201 and up. On the same
Electronics Forum | Tue Jul 18 03:11:48 EDT 2017 | tsvetan
I recently bought: PCB Loader, Full Automatic Printer with vision with 10 seconds print time, 1 meter Inspection Conveyor, Samsung SM482+Feeders, 1 meter Inspection conveyor, Reflow oven for similar budged, all machines new. I bought them directl
Electronics Forum | Mon Oct 24 01:19:10 EDT 2005 | darby
Hi Mike, I use variations of both of these machines in a Tenryu FV-7100s and Samsung CP45/CP45Neos. Both have been very good machines - I would find it difficult to split them. I have personal dislikes of both tooling and support systems. I would ta
Electronics Forum | Fri Jul 21 12:34:31 EDT 2017 | svfeingold
Hi Sumote, thank you for the advice! I actually visited the K&S service center, they are the company that now handles the Assembleon line. They have service/training techs there who have been around since it was part of Philips and are very familiar
Electronics Forum | Fri May 06 07:58:33 EDT 2016 | cyber_wolf
Darby, I'm not completely sure I understand. Juki machines have what is referred to as a multi-head. The offsets between the heads are the same as the spacing between 8mm feeders. So the (6) heads all come down at once and "gang pick" from 6 8mm fee
Electronics Forum | Fri May 06 08:27:38 EDT 2016 | kahrpr
We have Samsung and havehad no problems with simultaneous pick ups with 201s 0r 402s. the feeders are durable and do not need much repair especially the sm feeders. The SME feeders have not been out as long so we will see so far so good. As with all
Electronics Forum | Thu May 05 19:13:33 EDT 2016 | darby
Thanks Sr. If you have zero tolerance for simul pick up in your component files then you will not have simul pick up due to variances in your head offsets. So you are saying that on your Juki you run a tolerance for 0201? All other head positions at
| 1 |
