Electronics Forum | Mon Jul 14 12:11:17 EDT 2014 | rgduval
We used to use the Tapesplicer tool available from http://www.tapesplice.com (Sierra Electronics), in a high mix, low volume environment with MyData's (older feeders). Short review: It worked. Longer review: First, technique is everything. Splicin
Electronics Forum | Wed Mar 20 12:59:10 EDT 2013 | kmots15
We had this issue with a few parts on our universal 8mm feeders. The set up was correct all mechanisms were working, even tried a new feeder. The spring in between the take up wheel and pick point just wasnt cutting it since the adheasion was too m
Electronics Forum | Thu Apr 19 20:21:07 EDT 2012 | eadthem
You might keep a eye on SMT auctions, Sometimes you can get a good deal. As long as you get the feeder for less than 100-200$ each at auction/ up to 500$ each for a dual lane, you can be assured that you can fix it to fully working if its broken
Electronics Forum | Sat Jun 27 17:49:24 EDT 2020 | jmelson
I can't find much info on the older Essemtec machines. First, I'd want to see the "spec sheet", then I'd want to find out what the programming environment is like. (I was really impressed with the Samsung machines in that regard.) I have not seen
Electronics Forum | Sat Jun 05 07:47:47 EDT 1999 | Dave F
| | | Has anyone had a problem with the trailer tape length being too short and causing placement machine to stop for parts exhaust (SMT parts)? I realize the EIA spec. is set for this length but would like to know what issues you have had. Thanks
Electronics Forum | Thu Aug 21 17:09:09 EDT 2003 | justin
Wow, You're breaking into some fun stuff. Holding WIP is expensive, ineffective, and typically gives you more quality headaches than you know what to do with. What are you going to do with your partially built up boards? Are you going to hand sold
Electronics Forum | Fri Nov 20 23:00:07 EST 1998 | David Lombard
| | Thanks for your reply. | | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | | My company is small in terms of number of
Electronics Forum | Tue May 28 13:34:57 EDT 2002 | johnw
There is alway's squabbles when people talk about utilization and then there's the fabled effective utilization, which rumour has it is differnt. Most of the time as you say the benchmark's aren't really there and as Mark point's out it depend's on w
Electronics Forum | Fri Sep 11 21:36:47 EDT 1998 | Steve Gregory
Thomas, I imagine if you could get everybody's opinion who's worked with vibratory feeders for any length of time, they'll all tell you they basically suck...it's better than nothing when you have to deal with tubed parts, but they still suck. Here's
| 1 |
