Electronics Forum | Tue Sep 12 15:35:46 EDT 2000 | Christopher Lysik
Universal Instruments sells the Sanyo chip shooter as the 4791 and 4796 chip shooter. If you go to www.uic.com you can get all sorts of info Universal is located in Binghamton N.Y. Universal has a office in the Chez Republic. They may also be able to
Electronics Forum | Fri Jul 23 10:33:14 EDT 1999 | Mark D. Milward
Has anyone had the experience of losing components after they have been placed by the HSP 4796 because of table movement. I've worked on the 4760s, 4780s, and 4785. I don't know if this is a problem or not. We are trying to determine if this a possib
Electronics Forum | Thu Jan 15 13:06:42 EST 2009 | stiva
Thnaks Pitbull That worked
Electronics Forum | Mon Jan 12 23:25:27 EST 2009 | sachu_70
Did you try explaining the problem to your machine manufacturer for direct assistance? Perhaps your machine brochure would indicate a 24hrs helpline service, or any contact no.
Electronics Forum | Mon Jan 05 04:58:12 EST 2009 | stiva
We have a machine that has the supervisor password is set and the current password is not known. Is there a way to reset the supervisor password? Is there a top level password above the supervisor level that can be input to enable me to access the ma
Electronics Forum | Thu Jan 15 13:02:55 EST 2009 | bigdaddysoy9
This is the procedure to reset the password in the UCT-52 software. I don't know if it will also work on the machine, but it's worth a try: To reset UCT 52 after you get a password has changed error, you need to type the master password in to reset
Electronics Forum | Mon Jul 26 00:20:50 EDT 1999 | HERMAN
| Has anyone had the experience of losing components after they have been placed by the HSP 4796 because of table movement. I've worked on the 4760s, 4780s, and 4785. I don't know if this is a problem or not. We are trying to determine if this a poss
Electronics Forum | Wed Feb 23 11:40:38 EST 2000 | TMV
I would definitely check the amount of adhesive/paste that you are putting on the board. It may not be enough for any moving table application. If you think you are OK there, lets go on. As you probably are aware, the HSP tact times can be independan
Electronics Forum | Thu Mar 01 11:22:17 EST 2007 | ausajid
hi is any body very good in programming for hsp4796a or hsp4796b. i am stuck in one thing and want any body to help me out. the problem is i am using alternate feeder alonghwith alternate carrige. i want machine to go on alternate feeder first and i
Electronics Forum | Thu Mar 01 18:24:37 EST 2007 | jaimebc
Set FEEDER AXIS in the box of the label ALTERNATE MODE at the OPERATION DATA display. ( to get there go to PROGRAM EDIT/OPERATION DATA/ then press next page. For reference look in your operation manual 3.7 ALTERNATE MODE.
