Electronics Forum | Mon Jun 15 05:09:47 EDT 2020 | compit
This is not calibrated - it is set with a screw. Send a model or photo.
Electronics Forum | Mon Sep 25 16:14:16 EDT 2000 | LarryK
What do you all do to fix coplanarity on fine pitch QFPs? I know that the best thing would be to send them back to the vender, but what about the when you gotta use them? Straightening by hand seems to be so time comsuming. Any better ways? Larry
Electronics Forum | Mon Aug 16 14:43:44 EDT 2010 | dan_ems
Hello, i don't know if is possible to dispense paste but for reduction of cost we use a diferent type of stencils, from aluminium of 0,2 mm, purchased from a typography of newspapers. Ofcourse the pcb for what we use this stencil are simple. But th
Electronics Forum | Mon Aug 16 20:50:05 EDT 2010 | adhesivedispenser
CiXi Tian Hao Electric Technic Co.,LTD manufactures adhesive dispensing equipment and may be able to offer assistance with your application. Check out our product information at http://dispensing-th.com. We manufacture dispensing equipment ranging fr
Electronics Forum | Tue Sep 26 09:27:10 EDT 2000 | Chris May
LarryK, It all depends upon your volume / problem. As Jax says, if this is a repeating problemo, get QA & Purchasing involved. Is it your stores ? Do they receive 100 off and "decant" 20 into a tube (manual handling error, training etc;). From your
Electronics Forum | Thu Mar 05 16:29:22 EST 1998 | Brian Stumm @ ETS
| Can anyone advise a good starting point for a temp profile for | on 0.05" and 1206 component boards? These boards are simple | by todays standards and do not contain any fine pitch or | other special components. | Thanks in advance... | MM Be hap
Electronics Forum | Wed Sep 10 15:37:31 EDT 2008 | scottp
At the risk of painting with too broad a brush: QEs are like seagulls: fly in, make lots of noise, crap all over things, then fly away. Back to the knob turning vs. analysis debate. Part of it may be different industries. We're in the high reliab
Electronics Forum | Wed Sep 10 11:34:05 EDT 2008 | patrickbruneel
Amen to that!!! When I was still on the production floor and had problems I couldn't go to the production manager and tell him/her we had to shut down the production line and have the boards send in for analyses. (He/She would have seriously questio
Electronics Forum | Wed Sep 10 12:20:52 EDT 2008 | grics
True words of wisdom. Production managers need product out the door, not tied up in wip waiting on an analysis to go and fight a vendor for errors in their manufacturing. Especially if you are a Low Vol High Mix facility. Quite frankly, the resourc
Electronics Forum | Wed Sep 10 12:56:26 EDT 2008 | vladig
No arguments there. I 100% agree that quality engineers can and do solve a lot of problems on the spot. I've nevern said "run an analysis as soon as you get a problem". The whole nine yard started with a solderability problem. In my previous product