Electronics Forum | Tue Mar 25 13:33:27 EDT 2014 | taiji
Do you already check that the machine controller computer is booting?
Electronics Forum | Tue Mar 25 15:16:16 EDT 2014 | yuran111
machine controller BIOS loads only cyclically until pressed reset button on it - now checks the configuration and loading tasks load. hard drive I can take from the controller Siemens s27 example? motherboard came from s27 machine, and the same softw
Electronics Forum | Wed Mar 13 14:10:16 EST 2002 | caldon
Could this be Brian Stockley??? A true Siemens God?? Cal
Electronics Forum | Sun Mar 10 07:43:59 EST 2002 | Tal
how siemens line computer automatic calculate the tolerance for the x,y body and for the Packaging X,Y Tol ( i need a rule or formula)
Electronics Forum | Wed Mar 13 11:49:10 EST 2002 | stefwitt
thank you, Dave, I replied to Tal's e-mail. I am not aware of any formula used to determine the tolerances. We were collecting data from Topline, Siemens and other component supplier. On small components, the aim was to detect components on the side
Electronics Forum | Wed Mar 13 12:02:34 EST 2002 | davef
Did we catch you napping?
Electronics Forum | Tue Mar 12 22:40:43 EST 2002 | davef
Shoot a note to Stefan at http://www.steering-inc.com Check out his manual Siplace for dummies
Electronics Forum | Wed Mar 13 09:08:40 EST 2002 | stockley
It is a little bit sad that I know this - be prepared for some confusision - this is not as simple as it might seem. Something tells me that the calculation of the tolerances for the nominal dimensions is a little inconsistent. As I recall the defa
Electronics Forum | Wed Aug 28 20:01:17 EDT 2013 | vinodkumar
can anyone help me how to get Siemens Line computer installation floppies or someone mail me the contents of the floppies of 00345544-01,00345542-01. I assume it is boot disk of 3-4 numbers. Request you to mail it to me or load it to a site and give
Electronics Forum | Sun Dec 11 09:14:45 EST 2005 | andrew1007
Dear sir, I am a SMT engineer from China. I have diffculty in programming and maintenance of Siemens HS180,SP120.Can u send me some manual for the type of SMT machine.Thank you very much. my e-mail box is andrew1007@hotmail.com Regards!