Electronics Forum | Sun Jul 25 08:54:37 EDT 1999 | Tom Gervascio
| We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after
Electronics Forum | Mon Jul 26 14:14:51 EDT 1999 | Steve Gregory
| | | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is th
Electronics Forum | Fri Jul 23 14:07:52 EDT 1999 | Carl J. Odle
We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after a p
Electronics Forum | Mon Jul 26 10:25:12 EDT 1999 | Boca
| | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that a
Electronics Forum | Fri Jul 30 09:43:44 EDT 1999 | C.K.
| We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after
Electronics Forum | Thu Feb 15 07:04:59 EST 2001 | CRAIGS
Antonio, one possibility I have seen before on BGA shorts was due to chain slippage on the reflow oven due to worn gearing, the slippage was not severe enough to move other SMT devices but was enough to disturb the molten solder under the BGA
Electronics Forum | Wed Feb 14 21:14:45 EST 2001 | davef
BGA Shorting 1 Damaged mask in between the BGA pad and via on the substrate. 2 Poor print registration. 3 Poor via segregation from the pads? Are they tented or is there just a dam in between? 4 Review the profile. You can run into a number of p
Electronics Forum | Fri Sep 12 22:57:13 EDT 2003 | Dean
What is the surface finish of the PCB? Tin? Imersion Silver? What flux is used in wave solder and / or SMT? I have much experience with silver migration and tin wiskers. Both can disappear during a reqork cycle. Both can be extremely difficult
Electronics Forum | Tue Sep 04 07:34:02 EDT 2001 | Shvetang Dewashrayee
We have problems of solder shorts while using DEK Infinity printers. Some of the manufacturing lines are configured ina way that the side (bottomside) of PCBs mostly with passive parts is screened first and then the otherside (topside) of the PCBs w
Electronics Forum | Wed Mar 04 08:21:42 EST 2009 | rgduval
It seems familiar, but nothing that I've actually experienced. I've read some articles about tin-whiskering in lead-free solder. I think NASA has some pretty good analysis (or, at least they did a couple of years ago). The summary is that without
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694
