Electronics Forum | Wed Jul 27 01:34:17 EDT 2011 | JOSEPH PJ
hey am working in continuos improvement dept and am lokking foraward to save time and cost by imlimenting solder paste catridges in place of jars can any one help me out in this topic! with regards JOSEPH
Electronics Forum | Thu Dec 10 12:57:25 EST 2009 | scottp
We've used mostly cartridges for many years and I only saw separation once when a particular paste supplier had a problem. With cartridges it's just thaw and use - no mixing. We have some sites that use jars along with mixers and I've never been co
Electronics Forum | Thu Jul 28 07:23:24 EDT 2011 | scottp
My group supports a couple hundred lines all over the world. Most of them use squeegees but a few use either the MPM Rheometric pump heads or the DEK Proflow heads. I absolutely hate the enclosed heads. Flux separation, compaction, and the print q
Electronics Forum | Sun May 05 12:06:22 EDT 2013 | mbb
Hello, I'm looking for a mechanical system for fifo management of solder paste in warehouse in order to eliminate human errors while putting solder paste jars in fridges.
Electronics Forum | Mon Sep 26 14:07:52 EDT 2005 | jsloot
I am looking for input on a solder paste mixer for 500g jars. Does anyone have a good recommendation? Thanks
Electronics Forum | Wed Mar 14 16:10:38 EDT 2012 | cobham1
We need to develop a method of putting solder paste on a stencil then putting the unused part back into the refrig. Reason we are thinking of this method is because we only run circuit boards twice a week. I dont want to waste entire jar of paste bec
Electronics Forum | Tue Jul 16 08:39:05 EDT 2013 | cyber_wolf
The screwdriver can scrape pieces of the plastic jar off and contaminate the paste if you aren't careful.
Electronics Forum | Fri Dec 17 14:13:18 EST 2004 | Claude_Couture
I have done this several times in order to save my butt: adding liquid flux in a jar of not so fresh paste, stirring it slow for 2-3 minutes, to make it usable. Of course, use no-clean flux for no clean paste, etc. During one production slow-down,
Electronics Forum | Fri Apr 04 14:49:51 EDT 2008 | tombstone
Flux seperation is a common problem observed due to expiration of paste. The symptom is a yellow layer of flux when you open the jar. Excess flux separation will cause priting problems such as smearing and slumping.
Electronics Forum | Tue May 14 15:21:07 EDT 2013 | Keith Cathcart
I've seen a couple of customers create a jar dispenser similar to the ones you can buy for beverage cans. See this link for the examples used for beverage cans http://www.meijer.com/shop/chrome-organization-kitchen-storage.jsp Hope this helps. Kei
.gif)
