Electronics Forum | Sat Jun 07 04:01:56 EDT 2008 | carmanah
Hi all, Need advice how to fix RJ45 short issue after wave solder m/c .Few actions taken to resolve this issue but the outcome was inclusive which was 1. Modify wave pallet 2. Change conveyor setting from 0.8meter/minute to 0.7 meter/minute 3. Clear
Electronics Forum | Thu Aug 30 20:35:51 EDT 2012 | davef
A common bottomside heater configuration is IR-Convection-Convection. One of the big advantages of the IR zone is its ability to allow the flux carrier to spread and dry slowly before the board reaches the convections zones, which can blow wet flux c
Electronics Forum | Thu Nov 08 13:12:02 EST 2007 | russ
Annular rings are too big, it is acceptable to have shorts on the common conductors. I would be willing to say the "other" supplier may have modified the artwork as well. Good fluxing, preheat and proper immersion depth are key to eliminating short
Electronics Forum | Mon Nov 05 13:46:14 EST 2007 | ck_the_flip
That's where this website falls short. Sorry to b*tch, but there's lots of people who post here whose primary language is NOT english, and you know what they say... "a picture is worth a thousand words." Original Poster guy...try "Image Shack" to s
Electronics Forum | Thu Nov 08 09:51:09 EST 2007 | rgduval
Where are the shorts occurring on the 96 pin connector? Are they consistently in the same areas? It looks as though there are a number of pins connected by traces on the board, and/or the ground plane. This would cause a lot of repeatable shorts i
Electronics Forum | Mon Nov 05 00:51:58 EST 2007 | omidjuve
We have a problem with soldering of a 96 pin header connector(9001-11961c00l1a from kingmate) we use 3 different wave soldering but in all of the machines we have many short circuit between the pins . the wave soldering machines that we use is fr
Electronics Forum | Fri Nov 09 07:13:20 EST 2007 | hussman
You're joking rite? I mean the pitch between these two connectors is night and day. Of course you will get shorts on the 96 pin connector because your leads are right on top of each other. Now, what to do about it: You took a picture of the top o
Electronics Forum | Thu Nov 08 08:44:22 EST 2007 | aj
Hi, I have just taken a look at the Connector Images. Is there a difference in pitch between both connectors ? From the photo it looks like the Annular Rings are oversized on Image #1 especially around the centre area ( this might be the image ).
Electronics Forum | Sat Jun 07 09:13:18 EDT 2008 | beatrice889
You even try out control/cut the connector lead length & turn the wave pallet loading direction?
Electronics Forum | Thu Feb 13 10:15:09 EST 2003 | dwanzek
Bridges are front to back. To me this seems to indicate thieves would pull the solder away from the pins. I feel I am correct in that theory. Yes, it would be a good idea for us to bring in a consultant but I have the opportunity right now to make b