Electronics Forum | Mon May 29 23:39:11 EDT 2006 | Faizal
Can anyone advice me on the effect of SN100C wave solder on SAC305 hasl board? I suppose the silver content on the hasl pcb would leech(contaminate) into solder pot.? Would it affect the surface bonding between copper pad and the solder.?
Electronics Forum | Mon Oct 27 14:28:19 EDT 2008 | patrickbruneel
Do you refer to the highlight in the picture as a solderball? Looks more like copper to me.
Technical Library | 2021-10-20 18:21:06.0
The solderability of the SAC305 alloy in contact with printed circuit boards (PCB) having different surface finishes was examined using the wetting balance method. The study was performed at a temperature of 260 _C on three types of PCBs covered with (1) hot air solder leveling (HASL LF), (2) electroless nickel immersion gold (ENIG), and (3) organic surface protectant (OSP), organic finish, all on Cu substrates and two types of fluxes (EF2202 and RF800). The results showed that the PCB substrate surface finish has a strong effect on the value of both the wetting time t0 and the contact angle h. The shortest wetting time was noted for the OSP finish (t0 = 0.6 s with EF2202 flux and t0 = 0.98 s with RF800 flux), while the ENIG finish showed the longest wetting time (t0 = 1.36 s with EF2202 flux and t0 = 1.55 s with RF800 flux). The h values calculated from the wetting balance tests were as follows: the lowest h of 45_ was formed on HASL LF (EF2202 flux), the highest h of 63_ was noted on the OSP finish, while on the ENIG finish, it was 58_ (EF2202 flux). After the solderability tests, the interface characterization of cross-sectional samples was performed by means of scanning electron microscopy coupled with energy dispersive spectroscopy.
HASL - WHAT A HASSLE, or HASL'd AGAIN. If you don't see the images, please visit online version at #Application.SmtNet.baseURL#/express/ Featured Article HASL - WHAT A HASSLE, or HASL'd AGAIN. Proof Of Design MoonMan This article updates
SMT Express, Issue No. 5 - from SMTnet.com Volume 1, Issue No. 5 Wednesday, October 13, 1999 Featured Article Return to Front Page HASL WHAT A HASSLE, or HASL'd AGAINby Earl Moon INTRODUCTION This article updates one I wrote for Printed
Imagineering, Inc. | https://www.pcbnet.com/capabilities/assembly/tolerances/
, SMOBC/HAL, All Finishes acceptable Markings: Silkscreen, Solder Mask (preferred)…not required on PCB, assembly drawings can work as a replacement to silk screen Material: Rigid, Rogers 4000, Flex, Rigid Flex, Metal
| https://www.eptac.com/wp-content/uploads/2021/11/webinar_eptac_12_17_08.pdf
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
