Electronics Forum | Tue Dec 18 04:13:27 EST 2018 | bukas
hello everyone, i'm looking for a spray gun that can withstand flux aggression. I made air controlled prototype for ersa wave machine, but air guns wear out quickly and start to leak. I was thinking about Binks model 95AR or something with stainless
Electronics Forum | Wed Dec 19 16:05:10 EST 2018 | ldavis
I created a spray fluxer for our wave solder years ago that is still working well although does consume a lot of flux and is also rather messy. It's cheap and easy though so what the heck, right? I just machined a manifold that will hold four BETE
Electronics Forum | Tue Apr 05 17:42:57 EDT 2022 | amchirsan
I am looking to replace some spray guns that I have been using for a few years that are no longer reliable. You can see them in the attached picture. Does anyone had a brand/model that they would recommend? Any info or advice would be greatly appreci
Electronics Forum | Mon Apr 11 16:12:15 EDT 2022 | glasscake
MC Master has something similar but you pressurize the chamber with a nipple then have the unit disconnected from air.
Electronics Forum | Wed Apr 01 13:25:45 EDT 2009 | derek
Paasche has some nice HVLP guns.
Electronics Forum | Thu Apr 02 16:29:15 EDT 2009 | mikesewell
Always been fond of SATA HVLP guns, a little pricey though.
Electronics Forum | Wed Mar 25 20:00:32 EDT 2009 | davef
We are not sure what you mean by "any type like plastic, aluminum, stainless steel etc?" Binks [(US Corporate Offices), ITW Industrial Finishing, 195 Internationale Blvd., Glendale Heights, IL 60139; 630-237-5000 888-992-4657 http://www.binks.com] m
Electronics Forum | Wed Mar 25 17:35:55 EDT 2009 | smt_guy
Hi can you help me by recommending a paint gun for spraying conformal coating? any type like plastic, aluminum, stainless steel etc? thanks and regards,
Electronics Forum | Mon Oct 16 16:01:42 EDT 2006 | timnop
I have a wave machine (offshore made) with internal spray fluxer configured with a conventional spray gun set up. In order to spray fluid (in this case, flux) I must set the air pressure at 0.3 mPA (43 PSI). At that pressure, my flux sprayer creates
Electronics Forum | Wed Nov 06 18:27:18 EST 2002 | MikeF
At this time we will be hand spraying acrylic, probably using spray cans until we decide on a spray gun or an air brush, and get one ordered. Our volume is too low to even consider an automated system. Our current requirement is on an item designed