Electronics Forum | Thu May 21 15:43:18 EDT 2020 | ccouture
That brings me back, I haven't touched one of those in 15 years. But If I remember right, some of the control cards have rechargeable coin cell on board and they might be weak. Do you have access to Panasonic support?
Electronics Forum | Fri Oct 28 02:18:03 EDT 2022 | kamedatec
I bought a YV100XG machine with AutoTC (Automatic Tray Feeder), Everything is working except AutoTC, when I active this function, pops up the error that the Servo Motor LZ1 was not found. I changed the control card of the servo motor, checked the wir
Electronics Forum | Tue Nov 01 16:09:38 EDT 2022 | kamedatec
The machine had the Auto Tray installed but was removed to put here in the company because the machine was bigger than my elevator. The owner told me it was working, which made me waste time testing all possible settings, electronic cards and cables.
Electronics Forum | Thu Nov 17 21:46:48 EST 2005 | C. Kolokoy
With DIP type components, a sub-par fluxing method (foaming a no-clean), and a chip wave where one is not needed are formulas for bridging and insufficient wetting. If you have SMD's on the wave solder side of the board greater than 0603, and no SOT
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Wed Mar 18 16:15:49 EDT 2020 | emeto
Katrina, if the machine will zero on its own, there is nothing wrong with machine itself. You can now look into network cards in both line computer and line PC.
Electronics Forum | Tue Mar 17 16:27:32 EDT 2020 | sportsradar
With LC off, the machine when told "Without LC" will zero set. It displays Error 746. After zero set, turn LC on, and it hangs up. Error 746 is IEC blocked, solutions Reboot machine and PC. And we know, rebooting isn't getting me anywhere. What car
Electronics Forum | Wed Mar 18 18:22:32 EDT 2020 | sportsradar
I have replaced both cards on the machine and the card in the PC. I have also replaced the cable. I can see where the machine is sending the request for data (by the screen shoots above). And I can see the PC is seeing something from the machine by
Electronics Forum | Thu Mar 05 23:04:44 EST 2020 | sarason
My advice for what it is worth. Your description of the problem at first glance suggests a communication problem, now is it the bus, the SMT machine or the PC. The bus could have a short or an open. The PC could have a dud controller card. or so co
Electronics Forum | Mon Mar 09 16:22:05 EDT 2020 | sportsradar
Hello Kristof, We use 1 PC which does line control and programming. We always boot the PC up first, then when it is fully booted, then we turn the machine on, we let it zero set, then we send the job over (this is how we do it when everything works)
1 |