Electronics Forum | Sat May 24 03:32:24 EDT 2003 | Benny
Hi Is there any adapter that adapts between SMT and thru hole ?
Electronics Forum | Tue May 26 22:13:15 EDT 1998 | Pat Copeland
R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommende
Electronics Forum | Sun Jun 07 09:43:11 EDT 1998 | Bob Willis
There are some guidlines on design and through hole reflow on my web site to download. Also on pin in hole reflow the SMTA Office has a document on using the tecnology. | R&D is currently designing a board with smt components on both sides of the bo
Electronics Forum | Wed May 27 10:19:43 EDT 1998 | Jerry
We have no problems but orientation does matter. Orient with longest side of component body perpendicuar to wave. In other words the same preference as with through hole DIPS. Idea is the same as for through hole, that the surface tension will ten
Electronics Forum | Sat May 24 07:21:51 EDT 2003 | davef
Try: * Aries 908.996.6841 * Antona 310.473.8995 * Oztech 510.782.2654fax2656 * Emulation Technology 408.982.0660 800.232.7837 fax 0664 emulation.com * Interconnect Systems (BGA/BGA, BGA/QFP, BGA/PGA) 708 Via Alondra Camarillo CA 93012 805.482.2870 fa
Electronics Forum | Wed May 27 13:42:08 EDT 1998 | Chrys
| R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommen
Electronics Forum | Wed May 27 14:35:52 EDT 1998 | Justin Medernach
| | R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recomm
Electronics Forum | Wed Feb 28 11:43:20 EST 2007 | realchunks
Marcin, Think outside the box. If you are glueing the SMT part down, why not have an aperture cut in your stencil (or recut a stencil) between the SMT part and thru-hole. Wave solder hates SMT glue. This will get rid of your solder short problem
Electronics Forum | Fri Jul 30 16:41:14 EDT 2004 | Dave
Consider a 6 layer board. The Through via gets drilled from top layer to bottom layer. All 6 layers has the hole drilled in it. A blind via is a via that does not got through the entire 6 layers. It would go from layer 1 to layer 2. or layer 6 to lay
Electronics Forum | Wed Feb 16 16:41:31 EST 2005 | Mrduckmann2000
Pallets will not work in this case because the wonderful designers put 0402's between the legs and all around the legs of the thru-hole connectors. There are 18 thru-hole connectors on this board and 200 - 0402's around them. The 0603's that are al
.gif)
