Electronics Forum | Thu Oct 07 09:59:01 EDT 1999 | Dave F
| I recently had the opportunity to visit the vendor who is making my boards. On my trip I noticed that the guy who was in charge of the SMD placement machine (brand new Samsung) still had to manuallly place about 20%-40% of the parts after placement
Electronics Forum | Tue Feb 07 10:25:37 EST 2017 | ttheis
Thanks for the tip. I'm still getting familiar with the machine by reading the manuals as I have time. Was wondering what type of solvent you use to clean the dispensing mechanism parts? Or do you not clean anything and simply dispose of the syring p
Electronics Forum | Tue Feb 07 12:26:14 EST 2017 | westshoredesign
Oh yeah, so we have a auger valve similar to that on one of our other machines that we use for dispensing SMT glue, and solder paste also. We have a conditioner that we flush it with at EOD when in use, then we just let it sit idle with the condition
Electronics Forum | Sat Aug 07 11:10:03 EDT 1999 | JohnW
| Could someone give recommendation on the stencil opening for printing epoxy on HAL FR4 PCB for 0805 and 0603 size chips capacitors and resisitors. | My regular stencil manufacturer recommend the following: | Thickness: 8 mils | 0805 opening: Oblong
Electronics Forum | Mon Nov 15 15:31:54 EST 2004 | GP
We are looking for machine that can do the following: bonding of 0.5x0.5x0.8mm mm cramic part. - detect target surface position 1.5x0.8mm - dispance a drop of 0.8mm of epoxy adhesive on trget surface with position accuracy of +/-0.04mm. - pick the 0.
Electronics Forum | Wed Jun 16 22:04:16 EDT 1999 | Dean
| WOULD LIKE TO DO RELOW OF 2 SIDED SMT BOARDS. USUALLY THE BOTTOM SIDE HAS RESISTORS AND CAPS ONLY. WHEN THE BOTTOM OF THE BOARD HEATS UP, THE PARTS ARE FREE TO MOVE AND ONLY SURFACE TENSION WILL KEEP THE COMPONENT FROM FALLING OFF. | CAN BOARDS BE
Electronics Forum | Tue Jun 08 17:31:15 EDT 2010 | whitewing
For protos and very short runs I already use a polyester stencil + pizza oven process which is fine except for the placement time and tedium. I'm partly trying to bridge the gap between that and stuff that needs subbing out due to quantity, and partl
Electronics Forum | Fri Jun 04 11:54:22 EDT 2021 | cbart
We do this quote often with our older Summit machine. there are a few ways to do this. all of these are assuming you have parts on the boards already and are working around them. 1- if you have a good tech that can add solder to the pads on the PCB a
Electronics Forum | Fri May 07 18:02:37 EDT 1999 | Bill Schreiber
Just a note about cleaning SMD adhesives. Cleaning does not need to be hazardous. Smart Sonic has a non hazardous process that has been used for over 9 years using a non hazardous detergent that has been certified by the AQMD as a clean air chemist
Electronics Forum | Fri May 07 18:01:11 EDT 1999 | Bill Schreiber
Just a note about cleaning SMD adhesives. Cleaning does not need to be hazardous. Smart Sonic has a non hazardous process that has been used for over 9 years using a non hazardous detergent that has been certified by the AQMD as a clean air chemist