Electronics Forum | Fri Feb 27 06:14:43 EST 2015 | bobpan
press the control and output button at the same time to toggle back to v enter command. good luck
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Tue Mar 30 14:59:00 EST 2004 | Claude_Couture
no help from BTU, didn't buy from them so no support. I found the cause of the problem. The input of the controler relating to the conveyor alarm must have been stuck. By toggling the trigger value from Lo to High in the setup screen, I caused an ala
Electronics Forum | Thu Aug 19 09:38:24 EDT 2004 | russ
We use a locally made fixture that uses tooling pins and a mating block to place the connector onto/into. We then use a toggle clamp to push the connector onto the board. We had to make no adjustments to stencil for our application. Russ
Electronics Forum | Tue Jan 18 11:47:10 EST 2005 | clarkk
JB, I've toggled between front and back lighting and the results are about the same. But thanks anyway for the suggestion. Clarkk
Electronics Forum | Thu Apr 06 18:31:27 EDT 2006 | jsloot
Any one familiar with a board clamp problem on MPM UP3000? The one I have will not clamp the board when program is running. It will work when toggled through the output diagnostics. Any help is appreciated.
Electronics Forum | Tue May 17 11:12:09 EDT 2016 | bobpan
Press both buttons simultaneously. Press black button 3 times. Led will flash then go solid. This will toggle the pitch between 2mm and 4mm. have fun.
Electronics Forum | Mon Feb 04 17:53:58 EST 2019 | arbpkevin
My topaz X does the same thing. Hope someone can explain this. I have to toggle the button every single time after the first board.
Electronics Forum | Thu Jul 18 12:45:49 EDT 2019 | dekhead
Lots of things it could be (basics first): E-Stop pressed. Connections within E-stop circuit (mostly Y4). Connection of SYSTEM switch back to Y4. E-stop relay. Do double pushbuttons toggle partial SYSTEM?
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma