Electronics Forum | Fri Feb 13 16:13:20 EST 2009 | jax
Many shops require levels for typical component packages on FR-4 or a like substrate to be 2, 9, 15, 1 and 10 mg/in2 for fluoride, chloride, bromide, nitrate, and sulfate respectively. These levels can change for Medical or Automotive.
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Wed Nov 03 14:46:29 EST 2004 | dramos1
Hi Russ, Thanks for the reply. In IPC-A-610 Rev. C on section 5.2.9 {Mounting - Connectors] page 5-21 on the manual [January 2000], the acceptable class [1,2,3]listed 3 items. In order for the connector to be accepted, are all 3 items must be met? I
Electronics Forum | Thu Jul 11 14:59:22 EDT 2002 | pjc
Right or wrong, Mydata has a "second user" registration fee policy in order to recieve support. If you paid the fee then you get support. If you are a re-seller and not the end-user, that may explain the treatment you are getting. If you are an end-
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Thu Aug 07 13:58:01 EDT 2014 | patel_daxa29
Hi All, I have generated Pick and place file from ALtium designer.I put it on flash drive and it is plugged in MY-DATA. How do i access this file in TPSYS. I will appreciate any insight. Thank You
Electronics Forum | Fri Aug 06 14:06:04 EDT 2021 | cyber_wolf
Hit the space bar when the tpsys menu comes up when booting . There is something in there that says show transducers. I think that's where you will find z-force sensor
Electronics Forum | Fri Aug 06 17:19:46 EDT 2021 | SMTA-64387687
It seems to me that something is out of calibration. I noticed that you were reinstalling TPSys. Did this start after the reinstall? Did you restore a backup of your parameters, or recalibrate the machine with new values? Try changing the tools to "n
Electronics Forum | Wed Jan 02 10:45:02 EST 2019 | tech1
Exactly how are you exporting it? You need to export it in TPsys format followed by Export PCB only
| 1 |
