Electronics Forum | Thu Aug 31 14:15:34 EDT 2023 | compit
Hello What feeder do you use for the long connector (65-80mm) - tape feeder, tray? What nozzles? We want to mount a SODIMM200 socket. I don't know whether to look on the tape or on the trays... The MG1 spec says it will mount connectors up to 100mm (
Electronics Forum | Fri Sep 01 16:42:14 EDT 2023 | compit
I already see that most of these connectors are on trays - I just don't know if they are suitable for the machine. And I don't know what nozzles Yamaha/Assembleon/Philips use.
Electronics Forum | Fri Sep 01 11:55:27 EDT 2023 | tommy_magyar
In my previous job we fitted these connectors with bespoke gripper nozzles (ASM/Siplace) from bespoke trays made for these due to the high volume. It also reduces the risk of damaging the component further in case of a reject. However, at my current
Electronics Forum | Mon Sep 04 10:15:41 EDT 2023 | tommy_magyar
As far as I can remember, these always arrived in flexible plastic trays. The trays we designed were made of Durastone. The parts were then transferred at a tape & reel facility from tray to tray every 1000x connectors. If these are high volume for
Electronics Forum | Mon Oct 24 09:07:58 EDT 2016 | robl
Could you make up your own adaptor cable to connect to your programmer, then fit a small form connector like a Firewire on the edge of the PCB? It should only take up about 7x7mm of real estate as opposed to a 2.54mm 5x2 pin header 12.7 x 5.08, or a
Electronics Forum | Wed Oct 23 13:01:11 EDT 2019 | compit
I have a single-view camera on a Topaz-X machine. When I define a connector type element - it displays messages like in attached files. If I change the type to IC - no problem. There is also no problem when "learning&quot
Electronics Forum | Mon Oct 24 05:43:52 EDT 2016 | zxcvb
I have many PCBs that use an AVR in SMD packaging, and since I frequently change the firmware in prototype boards, I'm trying to come with the best solution to program the AVR quickly and easily. The first approach was to have a standard header (2x5
Electronics Forum | Sat Nov 09 20:11:43 EST 2019 | richardcargill
I suspect configuration too. From memory, only certain heads are assignable as 'Fine'. Changing this parameter in the component data to Standard or QFP will most likely cure this as any head will accept those two options
Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit
It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower
Electronics Forum | Fri Jul 28 14:34:13 EDT 2000 | Gary Simbulan
Belive it or not, these boards were run through a Centech batch mode Vapor Phase machine. Single stage top side IR preheat. Vapor temp 218 C. Solder paste is an SN62 RMA.The boards were FR4 8 layer w/ solder mask, fairly conventional as might be e
.gif)
