Electronics Forum | Wed Jan 24 17:48:28 EST 2018 | ranap121212
Hello Could I ask for advice? We have new machines with a full nitrogen tunnel. Type of soldering nozzle: worthmann 5 rows and next nozzle (in this same machine) worthmann 7 rows. One person in my organization claims that the delta nozzle is not wor
Electronics Forum | Fri Aug 30 06:18:55 EDT 2002 | seje
Thanks Jim, that should help. And yes, there is light at the end of the tunnel.... now : ) -Sasu-
Electronics Forum | Wed Mar 05 16:39:51 EST 2003 | Kris
Hi, Is it necessary to have a tunnel nitrogen? Is it a very common practise amongst contract manufacturers ?
Electronics Forum | Wed Mar 05 13:12:33 EST 2003 | msivigny
Hello davide, the biggest advantage you'll find with a complete N2 tunnel is the minimization of oxidation during board preheating. Using only an inerted solder pot allows the oxidation to build up throughout the preheat stages and introduces contami
Electronics Forum | Wed Mar 05 16:58:40 EST 2003 | msivigny
Hello Kris, No, it's not necessary to have a nitrogen tunnel setup. A nitrogen tunnel allows a process to go the extra step in providing higher quality through less defects. I can't really speculate on it's use in contract manufacturers mainly becaus
Electronics Forum | Tue Apr 04 02:46:39 EDT 2000 | George Verboven
We are looking for a way to cure conductive adhesive. I heard about curing times from 2 hours and more. But I also received information that curing can be done in 10 minutes at 120 C. Of course it also depends from the type of glue. But the question
Electronics Forum | Thu Jul 15 18:50:43 EDT 1999 | Raeto Zryd
We intend to use VOC free fluxe in our nytro machine. Does anybody know if there can be problems with water ie. solvent residues in the tunnel. Perhaps there are some white papers available on that issue.
Electronics Forum | Fri Feb 20 09:31:02 EST 1998 | Chrys Shea
| Can anyone tell me any posible ways to help cut down on solder dross in an inert environment wave???? Any suggestions would be helpful. It depends on how the environment is inerted. Is it a hood, tunnel, or boundary (Electrovert Contour) system?
Electronics Forum | Wed Mar 05 11:53:34 EST 2003 | davide grosso
I want to know the advantage of using complete inert soldering wave machine (with Nitrogen, Tunnel concept) in comparison to use just a soldering machine withe inerted solder pot. Thanks
Electronics Forum | Tue Apr 29 11:19:09 EDT 2003 | davef
Metallization failure. A defect such as voids, cracks, separations, depressions, notches or tunnels or any combination in the cross sectional reduction that is a basis for rejection.