Electronics Forum | Mon Jul 13 15:31:20 EDT 2015 | antoine_fradette
i am looking to buy a Press-fit machine and was wondering if the foolowing tools work with the Tyco MEP-6T press is a good choice? molex: insertion:62202-9940 extraction:62203-0150 molex: insertion:62202-9780 extraction: 62202-9790 Thanks
Electronics Forum | Fri Aug 25 14:31:10 EDT 2000 | Dan Woodward
This message is way late, but ASG in Florida (part of Tyco Electronics)specializes in connector insertion. WWW.goasg.com. Drop me a note if you want any details.
Electronics Forum | Fri Sep 15 15:57:34 EDT 2006 | Steve
What kind of connector is it? How does the manufacturer recommend processing their part? We've had quite a bit of experience using Tyco 'Mictor' connectors, with their inserter. We paste both sides of the board then drop the board on the inserter. A
Electronics Forum | Fri Jul 10 15:00:30 EDT 2015 | antoine_fradette
I am looking to buy a pressfit machine and i was wondering wich one would work with these kind of tools. molex: insertion:62202-9940 extraction:62203-0150 molex: insertion:62202-9780 extraction: 62202-9790 Erni: 220629,220630 Erni:220635,220808,220
Electronics Forum | Tue Aug 24 17:59:10 EDT 2010 | davef
A board support must be used to prevent bowing of the board during insertion of the sockets. It should have a flat surface with holes or a channel large enough to receive the sockets during installation. [Tyco AUGAT HOLTITE Socket Application Note 11
Electronics Forum | Fri Oct 17 15:23:28 EDT 2014 | davef
First, don't exceed the maximum temperature of the battery, say 85*C [I don't know your specifics] Second, don't short the terminals of the battery. Third, the best way to wave solder a battery is: * Insert an insulating tab between the battery an
Electronics Forum | Mon Jul 13 12:45:54 EDT 2015 | antoine_fradette
i am looking to buy a pressfit machine, but i really don't know much about them. I wanted to know which one would work with theses tools. the molex tools are the most important molex: insertion:62202-9940 extraction:62203-0150 molex: insertion:622
Electronics Forum | Tue May 29 16:02:36 EDT 2001 | genny
500 insertions � 50 m gold => 300 insertions � 30 m gold => 50 to 75 insertions � 20 m gold => 10 insertions. " Dave stated that the 'm' referred to micro-inches. I could probably insert this board 1000's of times without a problem. Am I missing so
Electronics Forum | Thu Aug 30 07:22:31 EDT 2007 | jdengler
The dedicated fixture never really wears-out. You may need to change tooling pins and hold-down tabs, but it will still be accurate when we are all long gone. The adjustable fixtures seem to wear-out. Depending on usage and care it may go from 3 y
Electronics Forum | Thu Apr 24 10:04:25 EDT 2003 | paul_bmc
I have been trying to keep up with these machines for years and ever since Multitroniks was acquired by tyco the support has disappeared. I can no longer buy parts or get service for these machines. Is there anyone out there that may know of a comp
