Electronics Forum | Tue Jan 29 22:01:51 EST 2008 | davef
These test are largely useless. Check the fine SMTnet Archives for previous rants. Manufacturers of machines to use are: * Peel tests: Instron [Instron Worldwide Headquarters; 825 University Ave, Norwood, MA 02062-2643; 800 877 6674 http://www.inst
Electronics Forum | Tue Jan 08 15:53:30 EST 2019 | emeto
From the datasheet
Electronics Forum | Tue Jan 08 14:41:08 EST 2019 | jrogalski88
I am a fairly new technician with a rather large electronics assembly company. Its been an ongoing issue to pick and place small coils using our Universal SMT machines. Curious if any if the seasoned techs at smt.net have any recommendations as far a
Electronics Forum | Tue Jan 08 16:43:04 EST 2019 | bane016
Try with "120F" type part number:48503503 or 1220 1240...reduce pick up speed...
Electronics Forum | Thu Jan 24 09:50:59 EST 2019 | my3sons
We can handle this challenge. If you would like to get an RFQ on a custom nozzle, please complete our form: http://www.cotinc.com/nozzle/
Electronics Forum | Wed Jan 09 05:21:07 EST 2019 | jrogalski88
I will try this, thank you! Out of curiosity what about an 0807?? currently using an 1140 but there's still issues with that. I'm almost wondering if maybe parts just aren't sitting flat in the pocket so I'm getting pick and visioning issues.
Electronics Forum | Wed Jan 09 11:46:45 EST 2019 | bane016
Maybe you have to contact your machine support they can modify special nozzle for that component...i dont know what else you can try...or just contact your support and ask them what to do...we had a similar problem with LED diode on our machine..and
Electronics Forum | Mon Apr 17 16:22:29 EDT 2006 | jaimebc
Are there any users currently working with Unicam and Universal HSP and GSM? If so, what offline interface are you using? USOS or UCT-52. Was there any conflict between Universal's interface and Unicam? Thanks
Electronics Forum | Thu Nov 04 19:51:28 EST 1999 | John
Thanks folks. The current vendor is doing an alcohol wash, top and bottom, then performing an ionic test on 100 boards. I'm not to confident in the testing because the readings for a "clean" board are 25 ugm/sq in and a "dirty" board are 40 ugm/sq in
Electronics Forum | Thu Mar 31 23:14:18 EST 2005 | Steve
Russ if your asking me if covering the surface of the granite defeats the purpose then I'm lost. An ionizer is a very good suggestion but they are not inexpensive. If the table is grounded and the metal bars are on a grounded mat, laminate etc. then