Electronics Forum | Tue Sep 15 13:02:55 EDT 2009 | horvath83
What do you think about optimal setup for 8-hour working shift and 16-hour standby time. What is the most energy efficient setup for standby time? Complete cooldown or maintaining temperature in solder pot?
Electronics Forum | Wed Sep 16 09:04:12 EDT 2009 | stepheniii
All the heat that comes off the machine comes from powering the machine. The more heat that comes off it, the more energy that went into the machine. When the machine is cold there is no heat energy leaving the machine. Therefore complete cooldown
Electronics Forum | Wed Sep 16 09:29:47 EDT 2009 | patrickbruneel
There has been a thread on the subject in 2007 with record postings. Check here: http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=11796Message50533
Electronics Forum | Wed Feb 06 02:14:43 EST 2008 | mun4o
Hi, we use Vitronics Delta 6622 solder wave.I try to adjust high of backplate, but I don't know whether the adjustment is correctly.Now, when the frame enter in the main wave, solder flow in the same direction as PCB.But when the frame go above main
Electronics Forum | Wed Mar 17 04:26:44 EDT 2010 | mun4o
Hi, we have vitronics delta 6622 in your production.Problem with fluxer starting 3 weeks ago.Fluxer moving, but not spraing????I check flux system , and dont find any problems with machine.Clean the spray nozzle with compressed air , but nothing.may
Electronics Forum | Thu Mar 18 07:58:43 EDT 2010 | mun4o
It is a pressurized system, and , Yes , there are a message "No flow nozzle 1".Our machine have not 'ShoRate' gauge at the back of the machine.There are only 3 gauge for flow on the front side , like watch ???
Electronics Forum | Mon Mar 22 04:14:36 EDT 2010 | mun4o
Sorry,I saw 'ShoRate' gauge at the back of the machine.Yes, when fluxer working, the ball moving.But from fluxer head flow only air.
Electronics Forum | Thu Feb 14 04:40:38 EST 2008 | lococost
You want the backplate set up so that when there's no PCB the wave stands still or moves towards the PCB. When the PCB moves over the wave, it should just pull the wave towards the back (in the same direction as the PCB). This will help reduce brid
Electronics Forum | Wed Mar 17 10:12:16 EDT 2010 | dj_jago
Is it the pressurized system or the pump system you have fitted to the machine? Are you getting an error message 'No flow nozzle 1'? Check the 'ShoRate' gauge at the back of the machine and make sure the ball bearing rises in the glass tube when you
Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg