Electronics Forum | Fri May 02 11:09:13 EDT 2014 | pawloa
Hello. We have a Minipak 300 wave solder machine from Electrovert and are looking in particular for a tachometer that attaches on the finger conveyor motor to measure the speed in pulses. We are also looking for the thermocouple that is used to moni
Electronics Forum | Thu Jul 06 04:41:58 EDT 2006 | Rob
MF300S is quite an old flux, & a lot has happened since then on the flow solder front - are you sure it's designed for Lead free, or is it just a traditional flux that SHOULD work OK with Lead free?
Electronics Forum | Mon Jul 10 09:25:47 EDT 2006 | nodlac
Here is a nugget from the Data Sheet... Wave Soldering: Excess moisture on the PCB during soldering may lead to random solder balling and poor wetting of some solder joints. IT IS IMPORTANT that the flux solvent carrier (water) is fully evaporated a
Electronics Forum | Thu Jul 06 03:03:56 EDT 2006 | ronalds
Thank you all for your input. The MF300S Multicore flux is rated for lead free. There is not much dross or contamination. We are using nitrogen. I've tested the boards with the curing test of IPC-TM-650. I think you're all right about the preheat.
Electronics Forum | Mon Jul 03 05:39:05 EDT 2006 | ronalds
Hi, I am experience problems while testing wave soldering SMT components that are glued on the solderside (lead free). Between de leads of SOx type IC's and SOT's develop a great deal of solder beads. I have been using a RSS temp.profile while spr
Electronics Forum | Fri May 18 04:40:51 EDT 2007 | gregoryyork
Wash them in Saponifier frequently at around 40C rinse and dry thoroughly. I would imagine it could be going white if you have a resin system in the flux that is not water soluble. Ensure you are using suitable pallet material up to 300C for Lead Fre
Electronics Forum | Mon Dec 26 14:04:42 EST 2016 | luciano
Hi all, I'm having some troubles while trying to set up a wave soldering machine that was working just fine until a few weeks ago. The wave soldering machine is quite basic chinese made. It's 2 meters long, has spray fluxing and a short preheating
Electronics Forum | Wed Apr 14 20:48:43 EDT 2004 | Ken
Just a thought.... Some Fluxes require temperatures upto 260F (127C). Are you using water based flux or solvent (alcohol). I have noticed that many wave machines are NOT capable of preheating adequately when using water based materials. This can
Electronics Forum | Fri Oct 09 14:01:24 EDT 1998 | Bob Barr
Charles, I am using an Air-Vac PCBRM12 to selectively solder a 96 pin thru-hole connector onto an otherwise all SMT board. Cost is $8.6K plus about $300 per flow well (nozzle.) Went from a 6 minute cycle to hand solder the connector to 15 seconds o
Electronics Forum | Tue Nov 29 17:27:38 EST 2016 | dyoungquist
We have been using SN100C in our RPS Rhythm selective solder machine since we bought it in 2008 with good success. No issues with the solder pot. We are setting the pot temperature to 300C.