Electronics Forum | Fri Jan 19 08:03:07 EST 2018 | babe7362000
Is anyone Familiar with Yestech B2 Calibration. I can not get the Camera angle to pass. Please message me if you can help me. Thanks
Electronics Forum | Fri Jan 25 10:15:56 EST 2019 | babe7362000
Does anyone know what Led is used on the Yestech B2 light boards. I need to replace them and can not find a board, so I need to replace the LEDS. Or is it something else causing the leds to not go any brighter?
Electronics Forum | Thu Oct 04 14:38:00 EDT 2018 | babe7362000
Thanks I will try to calibrate again.
Electronics Forum | Thu Jan 25 07:48:37 EST 2018 | cgreiner
Send me your email and I will send you a calibration procedure that I used to adjust my B2 unit. Best Regards
Electronics Forum | Wed Sep 26 11:14:09 EDT 2018 | babe7362000
Can anyone tell me how to adjust the B2 Brightness? Sometimes it is hard to see the markings, because it is too dark. It has been awhile since I have done this. Thanks for any information.
Electronics Forum | Fri Oct 05 09:03:36 EDT 2018 | dontfeedphils
Yea, probably need a new board, which may be tricky considering how old these models are getting now. I had a B2 at my last shop and we upgraded to a Koh Young Zenith 3D. At the time, Yestech told us the camera in the B2 would go for around 10k jus
Electronics Forum | Wed Nov 07 14:24:50 EST 2018 | babe7362000
Is there a calibration file that saves on the Yestech after a Calibration is complete? and If so where is that located? Thanks
Electronics Forum | Wed Jan 31 10:37:10 EST 2018 | dontfeedphils
I believe there are three small allen head bolts that hold the camera card to the gantry. Loosen them a bit and ever so slightly move the card up or down depending on the angle.
Electronics Forum | Thu Sep 27 10:13:31 EDT 2018 | dontfeedphils
This should help out. You should have a fairly large calibration plate to use during this process as well.
Electronics Forum | Fri Oct 05 08:46:19 EDT 2018 | babe7362000
I was unable to calibrate the Brightness step. The Pot was adjusted but would not brighten any further than 42. Im thinking I will need a new board or if someone knows what LED part number is used? Any information would be great. Thanks
