Electronics Forum | Sun Dec 31 17:16:37 EST 2023 | ravikumargv
Dear all, We are facing Siemens F5HM machine zero point calibration issue, due to fiducial issue and we need to teach the fiducial position and it's not possible, kindly help us how to teach the zero point fiducial for calibration
Electronics Forum | Mon Jan 01 13:50:53 EST 2024 | micropak
Machine Zero Point Calibration is done in SiTest. What problem are you facing exactly ? The procedure is given in the student guide/ SiTest User Manual. I tried to upload a screenshot but couldn't.
Electronics Forum | Tue Feb 09 08:48:29 EST 2010 | davemacnemo
Machine has 2 FlexJets installed. Working fine until it started giving Theta1 following errors. Machine will not zero. Coincidental (I think) with this, the Low Power Power Supply behind the Power Distribution Panel failed and was rebuilt. It's worki
Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Tue Jan 29 07:54:47 EST 2019 | anonymus
Hi, I have GSM2 UIC machine, machine does complete zeroing successfully but without scanning feeder plate fiducials. I enabled feeder plates (rear and front), but the problem is identical. Can anyone pls help me?? Thanks
Electronics Forum | Thu Jul 20 19:51:40 EDT 2006 | darby
Are you trying to tie someone to an agreed wastage level or are you being tied? What machines are you talking about? What components are you talking about? The only acceptable wastage level is zero: but you can't get to zero until you've had some was
Electronics Forum | Thu Sep 17 18:22:06 EDT 2020 | astarotf
Hello We have a GSM machine with two heads from the universal company, currently the machine fails to zero and in production mode, when the heads increase the displacement speed in the Y axis, they stop immediately. And the error illustrated in the i
Electronics Forum | Thu Oct 02 12:22:26 EDT 2008 | JerryS
Hello Ok there is not much info here. What you have to mae sure of is several key factors. 1. Have you entered the correct stencil thickness. 2. Are you using the stencil gerber (not the paste layer) The paste layer is usually not adjusted for ap