Electronics Forum | Sun Jun 17 02:19:47 EDT 2007 | Frank
You can grab a measuring tape and get the size yourself. Those machines are pretty small, I can't see them weighing more that a few hundred pounds. Contact Juki (the real makers of those machines) and I am sure they could dig up the actual weight.
Electronics Forum | Mon Jun 16 11:07:26 EDT 2014 | mdavister
Does anyone out there have a copy of the Technical Manual for the Zevatech PM560? I'd take either a hard copy or scanned in pdf.
Electronics Forum | Fri Jul 04 16:42:03 EDT 2014 | menvox
I have technical manuals for Zevatech PM560, I can make you a hard copy.
Electronics Forum | Thu Dec 01 10:31:16 EST 2016 | stewartkramer
I'm looking for a Zevatech PM560 Technical Manual. There was an earlier thread now locked which mentioned someone looking and someone else supplying one. I was wondering if I could get a copy. Thanks
Electronics Forum | Mon Jun 16 23:15:41 EDT 2014 | sarason
Try asking the question in the Zevatech Yahoo group. https://ca.groups.yahoo.com/neo/groups/zevatech/files sarason
Electronics Forum | Sun Feb 05 08:02:57 EST 2017 | menvox
Hi, I need calibration jigs for Zevatech PM575 (JUKI KP620). If you have available to sell, please advise. Thx
Electronics Forum | Thu Feb 05 08:39:35 EST 2004 | pjc
Dave is correct in that the Zevatech is actually a Juki. Made by the Japanese Juki and labeled by the Swiss Zevatech. The PM 575 is somewhat vintage. I believe it may be all mechanical component centering. It may be OK for the 20mil fine pitch but ma
Electronics Forum | Sun Dec 21 23:24:38 EST 2014 | sarason
Try the Zevatech group on Yahoo https://ca.groups.yahoo.com/neo/groups/zevatech/files Buena Suerte sarason
Electronics Forum | Tue Jan 03 22:00:32 EST 2006 | fdr4prez
Yes Rick, you are correct, Zevatech HBA, PPM7 & > PPM9 were all designed and built by Swiss. That > was a long long time ago. Sorry, I guess I forgot about those old beasts. Then don't forget about the good old CATs and Microns made by Zevatech
Electronics Forum | Sun Mar 10 16:16:35 EDT 2019 | sam512bb
Good day All, I was curious if anyone has a source for Juki/Zevatech PM575 Calibration jigs? My machine's placement is off and various a bit and so it was recommended to calibration the laser alignment. Sadly, there are no service centers located a