Electronics Forum | Sun Mar 28 18:49:36 EDT 2021 | mekmat544
Hello, I would like to ask you if there is some formula how to calculate PTH hole and annual ring for pin in paste technology? Thank you. Mekmat.
Electronics Forum | Thu Jun 10 19:10:05 EDT 2021 | kojotssss
Hi, Get your account. https://software.indium.com/stencil-coach/pin-in-paste-apertures.php
Electronics Forum | Fri Jun 25 16:32:45 EDT 1999 | MMurphy
| | | hello, | | | | | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | | | thanks for the input | | | | | | wayne | | | | | | | | | | | We have tried this mainly
Electronics Forum | Fri Jun 25 03:16:38 EDT 1999 | Scott Davies
Wayne, Earl, I wish there was some way we could toss our wave solder machine forever! Unfortunately, we haven't found a way yet to do paste-in-hole reflow for large numbers of thru-hole axial and radial components, which we insert on Universal machi
Electronics Forum | Fri Jun 25 12:07:00 EDT 1999 | John Thorup
| | hello, | | | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | | thanks for the input | | | | wayne | | | | | | | We have tried this mainly on thru hole connect
Electronics Forum | Fri Jun 25 11:05:19 EDT 1999 | Christopher Cross
| hello, | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | thanks for the input | | wayne | | | We have tried this mainly on thru hole connectors (.035 pins, .1 s
Electronics Forum | Mon Jun 28 11:47:54 EDT 1999 | Christopher Cross
| | | hello, | | | | | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | | | thanks for the input | | | | | | wayne | | | | | | | | | | | We have tried this mainly
Electronics Forum | Mon Mar 27 21:09:29 EST 2006 | ms
Thanks Dave I'm not convinced the air is necessarily in the paste from manufacture - suspicious that it may be folding in during the change in direction of the print cycle - or as the paste travels across apertures. It is not necessarily in the fir
Electronics Forum | Sun Mar 26 19:02:05 EST 2006 | ms
Hi We are running automatic stencil printers, open squeegees, stainless stencil, stainless blades, print speed 25-30mm/sec. We have a frustrating consistency issue printing .37x.3mm apertures on a 45pin LGA (11 pads each side, 1 large ground in mid
Electronics Forum | Fri Nov 08 14:19:59 EST 2019 | dwl
You can try putting titanium stiffeners on the PCB to prevent it from warping. How thick is your stencil? More paste would give you a wider window however too much and you risk bridging. You could try over printing the pad at the heel and toe to get
