Electronics Forum | Wed Jun 17 18:38:21 EDT 2020 | dilogic
Blue rectangle on the screen is actual search area. Green cross points excatly to the component centroid how vision system determined it - so, your component was picked slightly off center but still within the range. Now, the reason for offset can be
Electronics Forum | Wed Jun 24 15:36:58 EDT 2020 | aveazey
Do you know which menu this is under? We had tried changing the X,Y Location in the Camera configuration but the changes didn't seem to actually change anything. We would power cycle the machine every time after changing the config file. We also trie
Electronics Forum | Mon Jun 22 01:49:27 EDT 2020 | vinitverma
I too would advise against converting a 3-phase machine to single phase. Eclipse is a single phase machine and not too difficult to find! It's a rugged machine and people still use them. Orion too is single phase but faster and less accurate than an
Electronics Forum | Tue Sep 15 17:03:18 EDT 2020 | edvardvojvoda
Hello! We have a DEK Horizon 03i paste printer. When we load a new program at change over, most of the time it lost the reference point for the camera axes. After that the fiducials coordinates changed automatically to minus values. The service said,
Electronics Forum | Mon Jul 26 12:04:57 EDT 2021 | proceng1
Are you using a regular barcode scanner, or a smartphone app? When I print QR style codes on labels, I often use my phone to verify the print, but I've found that sometimes, especially when I print very small, or a very dense barcode, my phone won't
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
Electronics Forum | Wed Feb 02 23:28:48 EST 2022 | cbeneat
Something we've run into in the past, not on those machines, a different brand completely, and I have no experience with yours. We were having what you described and what we found was during the part being scanned, there was a bolt that held the shro
Electronics Forum | Fri May 06 06:54:56 EDT 2022 | jojoled
I have JUKI KE760L, and did notice that, when In "Feeder data " I select feeder position say 20, it enters XYZ coordinates for "pick coordinates" for example X=-260, Y=-25, Z=-1, which I need to "correct always by camera (it is slightly shifted).....
Electronics Forum | Wed Jun 01 12:06:49 EDT 2022 | proceng1
I am not quite clear what you are asking, but I'll give it a shot. Once the P&P program is put into the machine, the operator will load a bare board and step through the program using the machine camera to verify that part outlines match up to the bo
Electronics Forum | Mon Jul 25 23:05:40 EDT 2022 | kamedatec
I did something similar on Neoden machines. VisualPlace software helps a lot with this task, but the coordinates are never in the correct area where the PCB is, so I manually check the position of the first component and my software adjusts the posit