Electronics Forum | Fri May 28 15:03:34 EDT 2004 | jaytorres
Wierd thing happened today with the HSP4791. All the programs and component definitions were wiped out (luckily they are all backed up on the terminal). And since the air compressor was shut down today to change the oil in the compressor, the 4791
Electronics Forum | Tue Jul 27 19:02:46 EDT 2004 | pdeuel
Not an easy task and requires calibration jig. MPM support field service is your best bet. The adjustment screws for the prizm located on left side of camera will adjust the x direction. There is a set screw on the front that must be loosened first.
Electronics Forum | Sat Jan 08 00:47:12 EST 2005 | Grant
Hi, Yes, one of the problems with the MYDATA is the feeders are in groups, but at the same time, they are simple, and don't break. But the new Agillis 12 and 16 mm feeders do jam a bit. It's worse on glued cover tape, while heat bonded cover tape is
Electronics Forum | Wed Nov 09 11:01:41 EST 2005 | DannyJ
Hi Red and Greg, First, to Avalancher, the service that is mentioned is fantastic. I have used it various times with various connectors and headers with fantastic results. Just contact MyData and they'll tell you what they need. It's usually 5-1
Electronics Forum | Wed Apr 26 14:06:46 EDT 2006 | mdm4ua
Hi JEM, We just made the very same upgrade you are looking to make on three machines. We purchased a new MY12 and upgraded our other three (My9 W/hydra, My9 No Hydra, and TP9-2U) from 2.2.4C to 2.4.4c. There are several changes and most of the
Electronics Forum | Fri Nov 03 11:36:34 EST 2006 | mika
Hi, It is good news to "hear" that You found the problem. This control board has also broken for us once but we had a broken camera unit from where we took this board as a replacement. Unfortunately I was not able to find the circuit diagram (among a
Electronics Forum | Wed Dec 02 11:15:35 EST 2009 | tpappano
wycliffe (and I suppose anyone with a vision system): You may save yourself some considerable headache with your CSM84VZ if you check one simple thing before you get too far: Make sure the long skinny macro lens on the head camera is screwed in snu
Electronics Forum | Fri Aug 08 11:37:09 EDT 2008 | pjc
Yes, sure. In fact in some applications ICT is coming back. Mainly due to the fact that more and more SMT discrete components have no markings, so AOI cannot tell you if you have the correct value on the PCB. Fixed pin or flying probe ICT is a valuab
Electronics Forum | Sun Aug 31 17:28:09 EDT 2008 | rezer
Hello federico, This is Reese. Yes, you can pick up tombstoned parts reliably with the M1. You cannot pick up lifted leads very well however. I have not tried other algorithms yet, just histogram analysis which is the standard method for inspecti
Electronics Forum | Fri Sep 05 19:56:56 EDT 2008 | hegemon
We did extensive side by side (by side) testing of three AOI machines Omron, YesTech and Mirtec. In the end, even with weighted scores, the difference in the top two machine was still only four/tenths of a point. Third place was a distant 14 points