Electronics Forum | Mon Jul 14 11:09:59 EDT 2003 | samaniegocesar
Hello to all. I have problems with IP1 Fuji machine, the machine was working properly and suddenly appear the erroc code 000C error task 0028 and error address F92228A0, I turn off and On again, I erase the memory but I have the same prblem, I can n
Electronics Forum | Mon Sep 10 12:18:05 EDT 2012 | benreben
Hi, what's the feeding sensor error? the sensor for cartrige or the sensor on cylinder up of feeder? manual is step mode? if you have the number of error at screen,i have the fuji error code help. in step mode the machine is very slowly,maybe the a
Electronics Forum | Wed Aug 23 14:44:07 EDT 2006 | johnw
They are various way to debug this problem, try booting into mecha check, The cpu wouldnt cause a vp error all that is related to the VP are 3 cards the gognex the vp card and the memry backup card. If this fails print out the trace machine code and
Electronics Forum | Tue May 25 05:04:10 EDT 2021 | fujipro
Error codes would be helpful. In most IPS error cases, the Documentation will not help you. For remeasuring the IPS are special Tools needed. You need to send the head to your Fuji Service.
Electronics Forum | Wed Sep 17 05:18:55 EDT 2008 | ralphspm
Our Fuji IP2 has a problem reading fiducial marks.It finds the mark(is shown on console display) but after time gives out the error statement "image display time over".It gives out an error status code of "FFFC" on the console display.Cannot find any
Electronics Forum | Tue Jul 15 17:30:38 EDT 2003 | ServGuy
00c is a hardware interuption Addr F92228A0 is out of the card rack, meaning probably the CPU or memory PCB is out of control. Swap the 1st and or last card in the card rack with another machine or from spares.
Electronics Forum | Thu Sep 15 15:17:21 EDT 2005 | GAK
What kind of error code do you get? Check your sensers my be bad.
Electronics Forum | Wed Sep 12 11:52:31 EDT 2012 | mtech88
Ben: you are right, I think the timing must be off some how. I will check the error code and post it back here. thanks David
Electronics Forum | Wed Mar 06 06:24:51 EST 2013 | aj
can you move the x1 axis manually? Also, what is the error code displayed on the screen? 1C######
Electronics Forum | Mon Nov 04 11:16:14 EST 2013 | cyber_wolf
What you are asking is not practical. ALL parameters in the part data are key. When parts get rejected, there is an error code generated at the machine. You need training and this is not something that is quick and easy if you have no experience.
