Electronics Forum | Fri Oct 19 07:27:09 EDT 2007 | fredc
I just looked in my MSC Industrial catalog and they have coils of shim stock which would be a hard temper in .031 thickness on Pg.1770. Also stainless sheets of cold drawn material .03 thick on page 1791.
Electronics Forum | Mon Jan 21 16:01:04 EST 2008 | fsw
All, I have a customer requirement for a PCB that has rounded corners with a radius of 0.031". Present brd house says this cannot be met. Any comments?
Electronics Forum | Mon Aug 27 16:40:15 EDT 2012 | cobham1
Ran them with stiffners and I worried about moving parts also but had the stiffners cut so that they could only go on so far which made it ok because The distance from the stiffners and parts was 1/16 of an inch no problem with movement.
Electronics Forum | Mon Aug 27 12:51:32 EDT 2012 | cobham1
I have run 0.031 boards. One of the things you may want to look at is the speed of the oven. With 14 zones you may be going to slow with the board which could be the reason your boards are starting to bow. You might also think about adding stiffners
Electronics Forum | Thu Nov 30 21:45:44 EST 2000 | Dave F
It's unlikely that anyone other than the biggest of whooses would think of 0.031" a fine pitch. I prefer 0.025" on tape with solder plated copper leads make in a shape that bears-up well after being driven over by a Mack truck, yet is compliant enou
Electronics Forum | Thu Jan 15 10:08:54 EST 2004 | ADAM
Guys Does anyone have any design rules for a 121 pin BGA . The pitch is 0.031 thou, the ball diameter is 0.0115 thou . I would like to know the following : Pad and via sizes/type on the bareboard ? Stencil thickness and aperture size/sytle ? Solder
Electronics Forum | Tue Mar 15 13:24:44 EST 2005 | pjc
There is equipment available to clean NC residues off low standoff devices, well below 0.8mm (0.031"), from Speedline Technologies- Electrovert and Accel. See this paper under Accel: "High Reliability Underfill Performance through Proper Flip-Chip D
Electronics Forum | Wed Jan 21 12:25:45 EST 2015 | dyoungquist
Kester makes a thermocouple solder: Alloy SN10PB88AG2 Flux "44" Core 58 Diam 0.031" I have used this to solder thermocouples to pcbs when profiling for lead-free temperatures. When done you can unsolder the thermocouple and reuse it again. This g
Electronics Forum | Thu Jan 07 10:19:43 EST 2016 | dyoungquist
In 2014 we paid about $40K USD for a new Heller 1707 MKIII (no nitrogen) which is a 7 zone oven. One does not need a 8-10 zone oven unless you are doing high volume. We use the 1707 for everything including lead or lead-free solder, 0.031" to 0.093
Electronics Forum | Wed Jul 29 18:51:29 EDT 2020 | davef
You're asking about unclad FR4 [G10 is not flame retardant] Just ask for 0/0 unclad FR4. Thicknesses: 0.010", 0.020", 0.031", 0.047", 0.059" 0.090" & 0.118" "What do you folks do when you need custom formers?" Call Butler Winding [I receive no benef
