Electronics Forum | Thu Feb 22 12:26:33 EST 2001 | traviss
I used a Blue M batch oven quite a bit to cure in works great. All you have to do is get the board up to cure temperature, 150C normally and your all set. It will probably be in there longer than the time required but at that low temperature it shoul
Electronics Forum | Mon Aug 06 15:54:06 EDT 2001 | Fox
I think that anyone who has any questions about Tyco Electronics' offerings as far as equipment should check out their new web site: automation.tycoelectronics.com One other note about the references to Dynapert equipment and their link to Multitron
Electronics Forum | Wed Oct 01 12:14:32 EDT 2008 | marvl
Dear Sir, I'm a Mechanical engineer working on a Medical Park facility. I need to know how much a/c I need to provide for the following machine: MS 450 HF 500mA/150kV 40kW high freq. generator AEC - automatic exposure control TS 99RT Line
Electronics Forum | Tue Aug 31 04:05:23 EDT 2010 | arjan
Hi Mark, Thanks for your responce! The stencil thickness and especially the reduction of 45% are not recommend by LT, did you came to this combination experimentally? We never have the illusion to produce voiding free, but now its around the accepta
Electronics Forum | Thu Sep 02 16:55:31 EDT 2010 | markgray
I ment LF318. We have a power supply board that has 3 different types of these LGA's and i have had great success with the reductions and stencil thickness mentioned. We had to go with 4 mil stencil due to the consideration of the other large compone
Electronics Forum | Sun Nov 19 23:28:38 EST 2000 | Richard Metrton
Hi, We are looking at both the Vitronics Soltec and the Ursa Hotflow with the flux management options and am intrested to hear what others on the forum think about these two products. We really want something low maintenance, and works well. I gues
Electronics Forum | Sun Jun 02 02:46:27 EDT 2002 | mjabure
Just a couple of points in response. For the most part I agree with your point on technology transfer, unfortunately the US has been doing this for years. As for who would want these older machines and how could you make a profit off of them. There
Electronics Forum | Mon Mar 08 04:52:25 EST 2004 | martin
Hello i have some problem with our dynapert. Wonder if you could give me some advise. The problem is our machine worked not so well so we started to take out one by one of the cards and check all ic's so they was properly inserted. But when we ca
Electronics Forum | Wed Jun 15 00:50:32 EDT 2005 | Frank
From my understanding: Sigma is the same as one standard deviation. So 3 sigma is the same as 3 standard deviations. It all boils down to how repeatable your machine is. Another way to look at it is the probability (or confidence) that the machin
Electronics Forum | Wed Sep 20 15:25:15 EDT 2006 | lheiss
Hey All, Thanks for all of your help to date. While running the nozzle height test I noticed that the Z-rod is bent. Probably happened after setting the "X closed loop soft home" back to 50 from 384 which was probably why the nozzle slammed into t
