Electronics Forum | Sat May 15 13:24:17 EDT 2010 | dilogic
That would do if AIS3500 is working in the first place. As explained above, it does not operate correctly. Dead serial lines, jittery video output signals, internal 4 status LED's blinking in a repeating pattern (changing colours at the same time)...
Electronics Forum | Wed Jul 19 20:56:53 EDT 2000 | Dave F
hey, what the relationship between needle gauge and inside diameter
Electronics Forum | Sat May 15 13:25:49 EDT 2010 | dilogic
Yeah, I tried UNIDEC, but got no response to my e-mails, so I turned to this forum...
Electronics Forum | Wed May 19 17:33:41 EDT 2010 | dilogic
Thanks for the offer, but as I'm halfway accros the globe from you, it's not very practical for me...
Electronics Forum | Mon May 10 10:53:20 EDT 2010 | dilogic
Does anyone have some experience with AIS3500 on GSM1? It stopped to function just like that. I've opened it to check the batteries and I can see 4 status LED's blinking in a constant pattern, but I can't get any response over seial line from it...
Electronics Forum | Thu May 13 17:08:38 EDT 2010 | gregcr
prompt appears hit enter, another prompt should appear. Now set Diagnostic/Run switch to run, start vision system software load. The vision software can not load if the system is in running arbitrary code and hung in a loop so halting the controller
Electronics Forum | Wed May 19 17:54:41 EDT 2010 | gregcr
I have had problems corrected by swapping or replacing the power supplies in the box. Do you have a second GSM that runs the AIS3500 box? If so swap the power supply and see if the problem follows the swap. I have replaced the supplies inside the
Electronics Forum | Fri May 14 09:34:18 EDT 2010 | lockj69w
This procedure is from UIC's knowledge base. TO run Diagnostics on AISI 3500 vision. Use of this procedure will require reloading of vision executive once complete. 1. verify PC1 COMM2 is connected to COMM2 on the RADISYS board in slot 1 of VME chass
Electronics Forum | Fri Nov 22 12:34:14 EST 2002 | timreisenleiter
I am in the process of sourcing and ordering a BGA rework station. I only have exprerience with the OK-Industries (Now Metcal) BGA-3500 BGA rework system. Any experience/input on other comparable systems would be much appreciated (Pace TF3000, Air-
Electronics Forum | Mon Mar 03 16:36:51 EST 2003 | gregcr
I have a GSM that has a problem with the 3500EX vision box. The box has a AISI part number #700-3571-1 on it. Does anyone know who makes this? or if it is possible to service this item? I have replaced all the batteries already but there is a comm