Electronics Forum | Wed Oct 24 11:22:13 EDT 2007 | cyber_wolf
Let me add to the Mydata thing.. TP9-2U=..... TP9UFP=Good MY9=Best TP9 UFPs will place 0402's fine as long as you have black tools and run them across the camera. This method is slow but it works.
Electronics Forum | Mon Nov 19 13:35:25 EST 2007 | cyber_wolf
Be aware that there is a significant difference between TP9 2U's and TP9 UFP's.
Electronics Forum | Mon Nov 14 12:17:17 EST 2005 | avalancher
You should contact MYDATA service department and see what advise their phone support people can offer. You may not be doing the process correctly (wrong calibration boards, etc...)
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
Electronics Forum | Tue Feb 20 20:07:33 EST 2007 | mdang
My machine TP9-2U have the same problem. I use the camera to walk through the program and it is off and not repeatable. I think the machine has backlash but I don't know how to tighten it up. Can you help??? Thanks, -Michael
Electronics Forum | Tue Feb 27 21:20:23 EST 2007 | mdang
This is the TP9-2U machine and have about 2000 hours on it. When I used the camera to walk through the program, it is not repeatable.
Electronics Forum | Tue Jul 17 12:57:41 EDT 2007 | cyber_wolf
Is your machine a TP9 2U ? If you have a UFP or a MY series machine this condition usually points towards a bad X-wagon motor.
Electronics Forum | Sat Jul 28 09:25:10 EDT 2007 | mleber
We are new users to the Mydata product line. We are getting the following error F-Axis-23: X Transducer CH 1 ptp value too low. Has anyone had this error and lend some assistance? Thanks in advance.
Electronics Forum | Mon Aug 06 18:58:12 EDT 2007 | edruppert
This message indicates that the Peak to Peak voltage for the x axis motor encoder is too low. Possible cable/encoder or MOT1 board problem. Machine will either exhibit this during intialization or while running. Diagnostics in service routine may he
Electronics Forum | Tue May 07 13:41:36 EDT 2013 | cyber_wolf
MOVFI is a theta error there are about 10 things that can cause it. Start with making sure you do not have an acceleration set to lowest while the others are at high or highest in the package data. Next look at ribbon cables...
