Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search
Electronics Forum | Wed May 08 10:05:42 EDT 2002 | Claude_Couture
Maybe the problem is not the cutter, but the arm that advance the tape in the adjacent feeder gets actuated at the same time as the active feeder. line-up a feeder in pickup position visually, then turn the crank until the roller or feeder advance me
Electronics Forum | Wed Jun 04 08:54:46 EDT 2008 | sys_steven
We just had an issue where only slots 9 and up advanced on any feeder, an slot 2 advanced all the time. Slot 1 and 3-8 would not advance in any position. We replace the IC's at U12 and U13 on the M1 card, now slot 1 is the only one not working. We
Electronics Forum | Thu May 22 16:16:05 EDT 2008 | rmitchell
Hi, Our MY19 will not advance our slot 2 feeder in all tape and reel LM magazines. Other slots advance fine on the same magazine but #2 will not, no matter where we position the magazine along the machine. Any info-
Electronics Forum | Tue Sep 27 15:58:01 EDT 2011 | ck_the_flip
We use exclusively pneumatic feeders and can NOT control the force or speed of advancement. We get a lot of components (mostly LED-type packages) that tend to flop around in the pocket a lot and are flipped on the side or “thrown” by the feeder duri
Electronics Forum | Tue Oct 08 03:57:16 EDT 2002 | rsasalm
Hi all, Sorry in advance if the question doestn't see to fit here. I am working on Siemens C167CS microprocessor and looking for a forum where I can send question relating to programming C167CS microprocessor. Thanks in advance regards rsasalm
Electronics Forum | Sat Jul 08 10:44:49 EDT 2006 | larryw
Are you using the old type FV or the new CL Feeders? We place melfs all day long and never ran into a problem with feeder advancement. Sometime the manufactures of the components apply to much glue to the tape which can cause problems with feeder adv
Electronics Forum | Wed Jun 28 18:05:13 EDT 2006 | Travis Eklund
I don't know about the TM8FC magazines but the Agilis magazines allow you to slow down the tape advancement speed. If you can, slow down the tape advancement on the TM8FC.
Electronics Forum | Wed Aug 27 19:06:49 EDT 2008 | joojoo
I am looking for an advance level soldering hands-on skill training to do rework on SMT and BGA replacement in the San jose area, California. If you know any training school in the area, please email me directly,thanks. noorkota@hotmail.com
Electronics Forum | Sun Jun 26 21:26:45 EDT 2011 | fholtman
I have a dead motor in one of our triple tracks, one of the three that advance the tape. was just wondering if anyone has been able to order this or any other motors direct or if they all have to come through Siemens. thanks in advance for any replys