Electronics Forum | Tue Jun 13 14:12:30 EDT 2006 | adlsmt
You have already come up with what I consider the industry standard fix. Attach your weight to one of those heavy duty black paper clips and it is pretty easy to move it up as the tape runs onto the floor. I know of a lot of people doing this. Not aw
Electronics Forum | Wed Jun 14 09:22:36 EDT 2006 | pavel_murtishev
Good afternoon, 1. Use only melf nozzles (Type 76) 2. In case if your melfs are picked up one after another try to increase feed time in machine setup, this will add additional delay and will allow feeder to complete feed cycle 3. Use the strongest
Electronics Forum | Sun Jun 25 08:51:02 EDT 2006 | cloggy
Problems like these are not caused by bad feeder quality. As described in the solution finding, the pull off forces of the cover tape are just too high. Cause is the blistertape and not the a feeder. Have you ever tested if the pull of force of the
Electronics Forum | Tue Oct 09 07:55:50 EDT 2007 | AR
What are the opinions of the Assembl�on ITF Smart Feeder users out there? How is it about the mechanical endurance and relialibility of these feeders? Any particular issues with these electronic feeders? Any particular width that is more troublesome
Electronics Forum | Fri May 03 01:25:33 EDT 2002 | gerits
Dear Sir, I do not want to mix in this "subjective" discussion but as an employee of Assembl�on (buider of FCM II, FCM multiflex 50, 75, 100) I can provide you with MTTR, MTBF, placement data (0201), software, and other (also customer) data on our e
Electronics Forum | Tue May 16 01:23:10 EDT 2006 | Base
Try Assembl�on. The 2.0 version just came out so the 1.x versions are probably no longer available. I believe they start charging you for it now, but it won't be much since the previous versions were free. If you can manage to track down a 1.x versi
Electronics Forum | Wed Jun 14 01:24:14 EDT 2006 | AR
Thanks ;) We even did some product development on that one. We took a normal bar of wave soldering alloy, sawed a suitable length off it and drilled a carefully measured hole through the bit of solder. The hole is wide enough so that the blister tap
Electronics Forum | Tue Feb 20 04:21:30 EST 2007 | Base
According to my assumptions you're looking for a 40kCph line. (300 days of 8hrs at 75% efficiency) What's the parts mix? I would say (and these are my favourites) Assembl�on AX-5 with 10 wide robots. This will give you 50k output with the ability to
Electronics Forum | Sat Jul 08 09:19:53 EDT 2006 | Larry
Samsung vs. Assembleon We currently have both Samsung/Dynatech and Assembleon Equipment. We started with two Samsung machines but the support, flexibility, component range, accuracy and speed of their machines just wasn�t there. The difference betw
Electronics Forum | Thu Feb 08 07:57:33 EST 2001 | CAL
DAVE F. Far be it for me to correct you, it is not my place. I just want to Calibrate your GPS a little. The short and sweet version- Quad was to sell Samsung machines under a private label. All was ok until Quad released a machine to compete with Sa