Electronics Forum | Thu Sep 23 10:28:33 EDT 2004 | JB
We are placing labels using a Hoover-Davis feeder with a GSM. Anybody else out there doing this? My question is: Are you using a special nozzle for this operation?
Electronics Forum | Thu Sep 23 11:50:54 EDT 2004 | JB
We are using a standard nozzle Once placed, the label is not flat, the ends of the label are slightly lifted on both ends. The label is .650 x .200 Have you guys run into a similar problem?
Electronics Forum | Tue Sep 28 12:44:30 EDT 2004 | JB
You are right, basically our options are down to a custom nozzle. Pushing down the label is not the route that I would go with. Thanks for your input and good to hear that you guys found a way around it.
Electronics Forum | Tue Mar 29 15:19:57 EDT 2011 | davef
IPC-9850. Surface Mount. Placement Equipment. http://www.ipc.org/TOC/IPC-9850.pdf MNVC. Multi-Nozzle Vision Centering [???]
Electronics Forum | Sat Jan 23 05:21:09 EST 2016 | spectrumsmt
Hi Rick, we sell a very good after market recalibration jig which is available to calibrate most makes including Samsung. We also sell nozzles and feeders! Please get in touch or have a look at the website spectrumsmt.com All the best Ian
Electronics Forum | Fri Feb 08 03:54:37 EST 2008 | muarty
I would think that you could quite easily use 0.6mm I/D nozzles even when using a hand syringe. As you say you are only using this for larger devices to prevent them from falling off. I am sure there are very reasonably priced small compressed air un
Electronics Forum | Wed Aug 13 09:20:05 EDT 2008 | wrongway
we tested this kind of part about 3 years ago did a few prototypes I did'nt know how it was going to work but our old amistar picked it and placed it just fine used a small nozzle with a o-ring on the end of it I think it did ok going across the wav
Electronics Forum | Thu Aug 08 13:09:38 EDT 2013 | cyber_wolf
Hege, there is no actual calibration of the thermocouple itself. You can however verify that they read correctly. Heller sells an option on their reflow ovens specifically for this purpose. I hoping that someone chimes in here that is NADCAP certifi
Electronics Forum | Tue Sep 17 15:40:59 EDT 2013 | 18424
Good day all, I wanted to get a quick poll from the folks running SAC305 in their selective soldering equipment. How are final results? How repeatable is the process, any machine related failures? pumps? nozzles? etc... I am just looking to get a
Electronics Forum | Tue Sep 17 15:47:04 EDT 2013 | 18424
Good day all, I wanted to get a quick poll from the folks running SAC305 in their selective soldering equipment. How are final results? How repeatable is the process, any machine related failures? pumps? nozzles? etc... I am just looking to get a
