Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Tue May 18 10:35:11 EDT 2021 | kumarb
Hi. See this thread which may help you: https://smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=22839&#Message85508
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Thu Oct 24 23:19:55 EDT 2013 | wesleyintelli
Heads 2 & 3 on our CP45 are placing poorly. We believe that the head cameras are adjusting the component positions incorrectly since the placement is perfect when vision alignment is turned off. Does anyone have any experience with this issue or acce
Electronics Forum | Mon Aug 04 08:02:39 EDT 2008 | leemeyer
Miro, The video has nothing to do with the Quadalign. On a good startup and with no nozzle installed run a "Function 30" and post numbers that you get on the handheld terminal. On a bad startup (nozzle in the down position) press the re button on t
Electronics Forum | Thu Jul 31 03:20:29 EDT 2008 | miroyu
Hi everyone I have Quad 4C with following problem. When I run machine "cold start" first power up it will run and initialize but after if I turn it off and back on it will NOT initialize. Z axis will push nozzle down and it will remain i that posit
Electronics Forum | Fri Jan 28 15:22:07 EST 2011 | dougt
The PLC240-AK is an IC on the stepper board used to control all the stepper driven axis. I don't remember which axis are driven by stepper motors, possibly the table (x axis). Which axis acts wierd or doesn't move when you home the machine?
Electronics Forum | Tue Sep 14 07:44:16 EDT 2021 | bukas
hi James. does this happen with every head or just Z6? Does the head move vertically at all? What ANC holder is selected in setup "Hole position detail"? There should be 4 options for "ANC hole position version". If the machine is CP45FV NEO then ANC
Electronics Forum | Mon Mar 16 06:12:32 EDT 2015 | bobpan
The first thing to do is to change the z-rod. Sometimes a very old z-rod spring will weaken causing it to reject many parts. If it only rejects parts after a nozzle change....you may need to put some super lube grease on the O-rings on the bottom of
Electronics Forum | Mon Jun 19 11:16:22 EDT 2023 | eurolan
Hi guys, we managed to fix it. This tool turned out to be impossible to find. What we did is mount the motor, mark the timing belt's position and loosen the screws that attach the timing belt to the head. This way we were able to move the position of
