Electronics Forum: backing (Page 2 of 403)

Wave solder flow over back plate

Electronics Forum | Thu Feb 21 12:02:03 EST 2013 | pbarton

We agree with all of what Patrick has said. Hopefully your equipment is capable of the ideal setup you describe with no back flow until the product hits the wave and then back flow until the product emerges the other side. One other reason to strive

Tape not pulling back on components causes machine to stop

Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000

Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in

SAKI AOI MACHINE PROBLEM

Electronics Forum | Mon Oct 12 00:55:02 EDT 2015 | edriansyah

Hi nhel, if you're talking about software back up. it's quite easy. normally when you're system are set by the SAKI tech, they will create a back up of the saki software. this is their standart procedure. mine were located on the My document. he put

Fuji IP3 Problem

Electronics Forum | Tue Aug 22 10:51:49 EDT 2006 | rmitchell

Hi, Hope your machine is back up and running. Are you sure it is not program or PD (part library) related? Try power off and back on and delete the machine program from the machine. Then- Power off and back on and see if the VP error is gone. It

Mydata TP11-UFP won't initialize

Electronics Forum | Tue Jan 04 13:00:07 EST 2011 | bk

The only x fan i can think of would be the x belt motor fan which is on the back of the black box sticking out of the back of the machine. If it's a heat issue then first thing to do is replace the 2 filters behind the 2 vented covers located on the

Jars versus Cartridges

Electronics Forum | Wed Nov 23 17:24:43 EST 2005 | adlsmt

With Jars you tend to mix used paste back in with new paste and there is also a lot of air in the jar. If you are high mix try using cartridges and putting the used paste in little ziplock baggies. You can rip the baggies open including tearing the s

Selective solder nozzels

Electronics Forum | Thu May 04 08:45:33 EDT 2006 | russ

WML is back?

Thermo runaway

Electronics Forum | Thu Jan 25 15:59:23 EST 2007 | slthomas

stupid back button

Wave solder flow over back plate

Electronics Forum | Wed Feb 20 18:21:49 EST 2013 | caurbach

A question for all you wave experts out there: We run our wave with a constant flow over the back plate. I know it's recommended that we set the back plate so that the solder sits just at the top of the back plate with surface tension keeping it fr

Re: Where's Earl Moon ?

Electronics Forum | Wed May 17 07:55:26 EDT 2000 | Wayne Bracy

Darn, thought time had slipped back a year or two and Moonman was back around, giving us all the good info, latest tech stuff, etc. But, then I woke up and found we are really in 2000 and nothing seems to change. Take care Wayne


backing searches for Companies, Equipment, Machines, Suppliers & Information