Electronics Forum | Wed Nov 18 14:42:22 EST 1998 | Dave F
| I heard somewhere that SMEMA has joined IPC, and that the association has decided to boycott Nepcon from | year 2000. Can anyone tell me if this is true | Nick: SMEMA and IPC are talking about merging (EP&P, 11/98, p 18). Below is a news release
Electronics Forum | Mon Jun 12 17:03:21 EDT 2006 | pjc
Its in the IPC 600 bare-board specification.
Electronics Forum | Fri Aug 28 23:32:39 EDT 1998 | Pete Sorenson
| Does anyone have any experience they are willing to share on Ag epoxy used as a copper through hole plating replacement? Was CEM3 used? | What are the limitations? | Thanks, | Steve I have used silver epoxy extensively for conductive bonding applic
Electronics Forum | Mon Jan 15 11:41:56 EST 2007 | davef
Questions are: * Does the component take solder when you dip it in the solder pot to test the solderability of the leads? * Can you get full barrel fill when wave soldering a bare board? * Is your flux reaching the top of the board through the hole b
Electronics Forum | Fri Feb 18 09:41:44 EST 2000 | James Lewis
Has anyone seen or put together a good collection of proper handling procedures for components and PCB's? I realize a lot of it is no-brainer stuff, but I need some depth for a training class we are putting together. This would include ESD, Moisture
Electronics Forum | Fri Feb 18 09:41:44 EST 2000 | James Lewis
Has anyone seen or put together a good collection of proper handling procedures for components and PCB's? I realize a lot of it is no-brainer stuff, but I need some depth for a training class we are putting together. This would include ESD, Moisture
Electronics Forum | Fri Dec 27 16:26:30 EST 2013 | davef
I expect to find the specification and measurement method for the bow & twist of an assembly to be on the assembly drawing. Comments are: * Expecting that an industry committee to write a bow & twist spec for an assembly they know nothing about is n
Electronics Forum | Tue Apr 11 10:30:46 EDT 2000 | Jeremy Smith
I am having a problem with some joints on a 100 pin pqfp and few different soics on one particular board. When viewed a 8x with a "Mantis" inspection scope the joints look as though they wetted to the ic leg but when probed the leg will pop loose.
Electronics Forum | Mon Feb 05 10:12:32 EST 2007 | slthomas
The use of booties isn't required per se, just considered a standard step necessary to reach the 10,000 target. You also need to vacuum (central vac system, NOT exhausting into the room) daily, mop weekly, have a one piece floor, blah, blah, blah....
Electronics Forum | Thu Dec 26 12:12:55 EST 2013 | igorfo
Dear Friends, I need your help to understand requirements and measurement methods for bow and twist of assembled PCB (PCBA have and SMT and TH components). I already check all posts on the site but didn't found any related to my question answers.