Electronics Forum | Thu Nov 30 16:36:04 EST 2006 | techgonecrazy
I think we can control temp... but I will have to look into it further and see. I know the ovens have flow control... but as I mentioned on the last message, our BTUs are operating off of a huge chillers on the roof of the plant.(once again, not sure
Electronics Forum | Thu Nov 30 10:38:39 EST 2006 | billwestiet
You are cooling too fast, and some flux and paste is worse than others... Can you control your cooling zones? Water Temp (higher)? Or Water Flow (less, effectively less cooling)? Changing water temp is prefferable over flow if you can do it. I h
Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy
This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I
Electronics Forum | Wed Nov 29 16:52:35 EST 2006 | techgonecrazy
OK... My problem with BTUs is that they are getting stopped up because the flux is not going from vapor form to liquid form; instead it is crystalizing (looks like a blizzard took place in the flux box and chiller boxes) and clogging up the flux box,
Electronics Forum | Mon Sep 19 17:21:14 EDT 2005 | rick
They're full of crap and are simply trying to get you into a Paramax 150. Depending on your product you could probably get by with a VIP-98.
Electronics Forum | Thu Sep 15 13:32:04 EDT 2005 | cyber_wolf
Does anyone have any experience with these ovens ? We are looking at purchasing a used one. Anything in particular I should look at when inspecting it ? Any comments good or bad appreciated..... Thnx, Sr.
Electronics Forum | Thu Sep 15 19:01:26 EDT 2005 | russ
I beleive what they are doing now for the blower issue is giving a lifetime warranty on them but they still haven't upgraded to prevent the frequent failures. Personally I prefer a warranty that I don't need.
Electronics Forum | Thu Sep 15 19:28:25 EDT 2005 | fastek
From a used equipment dealer's perspective I know they are always in high demand and are difficult to locate used. Them and Electrovert are the best.
Electronics Forum | Mon Apr 24 01:12:28 EDT 2006 | fastek
Sure...I can help. Reduce the temperature and the error will go away. Seriously though.....I'm not sure that oven is even capable of those temps. Is it even convection?
Electronics Forum | Mon Apr 24 19:18:40 EDT 2006 | sessioc
OK guys here is the skinny..... > > We need an > oven that can handle lead free temps without > slowing the belt speed under 28 or so in. per > min. > > BTU tells me that they don't recommend an > oven that maxes any less than 350 C. > > Is an
