Electronics Forum | Tue Jan 31 13:20:15 EST 2006 | mgdrouin1
Does anyone have any information regarding damaged caused to components due to overheating primarily with a heatgun? I'm having a hard time getting engineering to comply. Thanks
Electronics Forum | Tue Jan 31 13:22:15 EST 2006 | mgdrouin1
Does anyone have any information regarding damaged caused to components due to overheating primarily with a heatgun? I'm having a hard time getting engineering to comply. Thanks
Electronics Forum | Tue Apr 10 02:57:53 EDT 2018 | rob
Yes I would, most of our old Yamaha machines (before 2005) will do 30-35 microns @ 3 sigma with the fine camera option. Our Jukis with His res camera's will hit it too. You should be OK with most things after 1997 with the right camera choice (whic
Electronics Forum | Wed Sep 14 23:30:30 EDT 2016 | ariss_t
Hi, my 2cent.. u could try to check the sensibility of the camera board stop sensor.. maybe it detect something i.e support block.. do reply when u found the actual root cause.. thanks..
Electronics Forum | Thu Sep 15 06:45:26 EDT 2016 | awhite
Hi Ariss_T, Thanks! I actually did check that...that was one of my first thoughts as well. While in the I/O, I slide a raw board back and forth under the camera/sensor and it acted appropriately. I will definitely update this thread as new informa
Electronics Forum | Sun Oct 11 21:19:51 EDT 2009 | fulldrawmike
we have both flexjet and flexhead, we also have the new inline 7 head on some genesis dual beams we just put into operation. If you have a choice in flexjet heads take the inline 7. The flexjet 09 head is very labor intensive, stay away from them, e
Electronics Forum | Tue Mar 04 16:02:53 EST 2003 | Dave C.
We have auto-correct funtion on our Panasonic Create CM-301 placement machines but have never turned it on because of a perceived loss of placement time when the camera verifies placement. We look at the first article and correct placemnt if needed.
Electronics Forum | Mon Sep 21 04:23:16 EDT 2009 | smtbox
R series Features FCS (Flex Calibration System) highly regarded easy maintenance just got even easier! The optional FCS calibration jig is a simple to use system to re-calibrate placement accuracy. The machine automatically picks and places jig comp
Electronics Forum | Tue May 18 21:43:02 EDT 2010 | ashley
Hello mickd, 1) The EL data & Vision_type is NOT necessary when using MCS30 for IP1 machine. note : your input of the above might have cause confusion during VP, hence the OS error. 2) I would suggest the following... 2a) lower the Lead_check_are
Electronics Forum | Sun Aug 26 12:40:59 EDT 2001 | stefwitt
I would like to enter the discussion by tossing some numbers in. First of all I don�t like the 3 Sigma value. 3 Sigma are 2000 defects per mio. if I remember correctly. This means, if you have 200 components on the board, then every 10 boards have on