Electronics Forum | Thu Dec 20 07:08:07 EST 2018 | robl
Hi Prem, OK... Is it definitely ok before the oven, as it's a big part to move. Never had an issue with them. Has the part got the correct z height on or is the paste being displaced on placement What machine are you placing it with (is it laser
Electronics Forum | Mon Aug 21 10:47:48 EDT 2006 | FredC
Hello Mika, I just checked a windmill and a test nozzle we have on the bench. The useful travel of the nozzle before the risk of the crosspin getting stuck in the loading gate is 1.5mm, if it gets stuck it is the nozzle is 1.7 up. If the cross pin is
Electronics Forum | Mon Aug 21 04:20:49 EDT 2006 | Rob
Hi Mika, I used to work for the largest chip cap manufacturer in the world, and by far the largest problem we would see was cracking due to incorrect z height adjustment on Chipshooters. It can also cause solderballs and bad joints by displacing th
Electronics Forum | Fri Aug 25 11:29:09 EDT 2006 | mika
Thanks all for Your input. The thing is that we want to avoid to go in to the pattern program and change the height in the middle of running a board. For ex. We start a product, feeders are loaded in advance in the feeder preparation area, operator
Electronics Forum | Tue Oct 02 10:30:10 EDT 2012 | eniac
Difference in pick height from paper and embossed reel (typically) is 0.2 mm. Try to change your pick height and place height (different type of capacitors have a different height: for 100 nF 0603 and for 4.7 uF 0603 it's a big difference!). Can you
Electronics Forum | Fri Feb 22 13:17:56 EST 2008 | cyber_wolf
0201 Feeders are a different height than regular 8X2's I have put them on a surface plate and measured them with a height gauge. FYI: They make 0201C (Capacitor) and 0201R (Resistor)Again the difference between the two is height. Also it is CRITI
Electronics Forum | Sat Jan 08 06:37:44 EST 2022 | jineshjpr
Hi, Noticed that MPN--MAL215099913E3 used in one of our assembly with 22mm component height. In General 15mm height is right to set height calibration (98 % of the parts will be covered with this height dimensions except specific Connectors, Transfor
Electronics Forum | Mon Feb 21 16:06:10 EST 2005 | MR
I agree w/ JB; the package height definition is crucial. I have had problems w/ this in the past, and found that a resistor height was being used as a universal passive height for the capacitor in question. Properly defining the height fixed the pro
Electronics Forum | Thu Dec 08 22:15:46 EST 2005 | molosse21
Hi everyone, One of our customer is asking us wich one of these two components has a better resistance to vibration. Vibration can be a potential problem for them. He has the choice between a thru hole radial capacitor with near 0.400 in diameter an
Electronics Forum | Thu Aug 26 07:35:32 EDT 1999 | Robert Meston
For space contracts we have to mount chip capacitors/ resistors etc 0.1 to 0.4 mm from the pad height. This is to compenstae for the CTE differential in the substrate/component and also to ensure cleanliness. Does anyone have any new ideas on how t