Electronics Forum | Wed Nov 13 23:50:23 EST 2002 | iman
we changed our top/bottom clamping system in the Printer, to a side-edge clamping system. This removed the higher paste issue similar to your thread.
Electronics Forum | Thu Aug 07 11:17:51 EDT 2003 | 51165
Can someone help me with a Ref Side Clamp Mesh Error on a CP643E?
Electronics Forum | Wed May 25 19:11:49 EDT 2005 | jsloot
That I can do, checking the placement height that is and the clamps. I believe my clamps are 4mm. If your nozzles have survived 5 years how many placements is that...roughly? In the billions?
Electronics Forum | Thu Apr 06 18:31:27 EDT 2006 | jsloot
Any one familiar with a board clamp problem on MPM UP3000? The one I have will not clamp the board when program is running. It will work when toggled through the output diagnostics. Any help is appreciated.
Electronics Forum | Tue Jan 23 13:15:44 EST 2007 | stepheniii
Shouldn't the top of the board be at the exact same height as the top of the side clamps? Why are the clamps holding the stencil up off the board?
Electronics Forum | Wed Nov 27 13:07:07 EST 2013 | processman
Hi, Can somebody confirm the correct operation of the rear clamp rails on an Ersa Ecoselect 2.... Do they only activate when the PCB comes into the machine then release, or stay activated thru out the flusing, heating, soldering etc
Electronics Forum | Fri Nov 16 01:05:34 EST 2018 | ushir
Hi all. I require some assistance please. I am looking for clamping blades for an old Ekra E5. Does anyone know where I could source these from? Thanks
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Thu Nov 14 11:37:49 EST 2019 | tcpds
Do you still have the dek248 squeegee clamps/blades? please direct email me at thart@prairiedigital.com
Electronics Forum | Fri Feb 16 13:29:53 EST 2024 | mistrthou
We don't have that machine, but our other DEK's all share a solenoid. Air for both sides should be on or off all together. I'd check for an air supply to the clamps that switches when commanded to clamp or unload.
