Electronics Forum | Wed Dec 06 16:44:23 EST 2000 | CAL
We are currently using an Aqueous Technologies Ultrasonic Stencil cleaner with Petroferm Chemistry.We Just drop the blades in turn on....come back 10 minutes later...squeeky clean. Cal
Electronics Forum | Wed Sep 25 15:58:36 EDT 2002 | bschreiber
Hello Dave, I hope that electronic slap didn�t hurt too much. Robf, I am sorry that you did not agree with my initial response, but the answer is very detailed and most of the support material I have is only in paper format so I need to either snai
Electronics Forum | Sat Feb 03 20:30:07 EST 2001 | Robert
James, if you want to get a circuit board wet, then any cleaner will do. Tighter componentry and BGAs are different. Even if you submerge a BGA, the surface underneath it will not be effected. Thus you need to force the chemistry mechanically unde
Electronics Forum | Mon Aug 31 16:30:01 EDT 2020 | emeto
I would question your motive "There's no way that I feel comfortable shipping boards after a selective without cleaning them, the amount of flux on the board is significantly more than from SMT". 1. Who said that residue should be cleaned and why? O
Electronics Forum | Thu Sep 05 18:15:15 EDT 2002 | pjc
There are chemistries out there that will solublize some post-solder NC flux residues. I have had success with Zestron material Vigon A200 and Petroferm material Hydrex DX. Go to http://www.zestron.com and http://www.petroferm.com These are chemical
Electronics Forum | Wed Sep 25 10:22:21 EDT 2002 | matt2138
UltraSonic cleaners do a good job of cleaning both stencils and misprint PCBs. Make sure the frequency that the machine comes set to is ok to use with both stencils and misprint PCBs. If you are a CM make sure your customers are ok with using the ul
Electronics Forum | Mon Aug 31 16:55:48 EDT 2020 | kylehunter
> I would question your motive "There's no way > that I feel comfortable shipping boards after a > selective without cleaning them, the amount of > flux on the board is significantly more than from > SMT". 1. Who said th
Electronics Forum | Mon Nov 01 09:43:52 EST 2004 | russ
See Daves Answer above and change it to "paste mfgr." Also most all of the cleaning companies have chemistries. Are you cleaning noclean or W.S.? IPA works if you clean them manually, Or the chemicals that the Ultra sonics mfgrs recommend. Search
Electronics Forum | Tue May 20 12:20:58 EDT 2003 | billschreiber
Hello Mike, We have just sent out the press releases. 440-R SMT Detergent, the only chemistry to complete the EPA's Environmental Technology Verification (ETV) Program, as part of the Smart Sonic Stencil Cleaning Process, is now available for use i
Electronics Forum | Sun Jul 15 17:48:51 EDT 2001 | kerryn
You should check the archives, there has been much written on this subject in the past. Asking about the correct chemistry is wise. It never ceases to amaze me how many people think ultrasonics will work without the proper chemistry. Without the rig