Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Fri May 22 16:35:21 EDT 2020 | gabriel1blue
Thank you! I think the rotary counter motor went out or the belt broke? The left side is moving fine the right doesn't move at all. If I push the right side very close to origin point some times the machine will complete the process. I'll check that
Electronics Forum | Wed Apr 21 14:32:52 EDT 2010 | remullis
These ovens maintain good profiling as long as you stay on top of maintenance. I had 4 150's and 1 125. The biggest headache is keep the plenums cleaned (very messy). Also the blower motors have been replaced a few times on them as well. If I were yo
Electronics Forum | Wed Jan 31 17:01:34 EST 2007 | rw
I'm not that concerned about the solderability of the motor. Our customer is concerned about the outgassing of the conformal coat effecting the motor brushes. Silicone will break down into SiO2 and SiC will result from a spark between the brushes a
Electronics Forum | Wed May 25 17:58:07 EDT 2011 | rssimmons
The SimmScope is a first article inspection system that uses an overhead digital microsope on a motorized gantry to inspect the board - much like an AOI - except that it does not automatically make the pass/fail decisions. It is up to the operator to
Electronics Forum | Thu Jun 01 11:17:05 EDT 2006 | Dr.Lou
I ended up buying the Assembleon. MyData was the only other brand in the Northwest with enough of a presence to consider. The MyData salesman sank his own ship by being too aggressive, and his quote dropped 45% in one week when he found out we were l
Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e
Electronics Forum | Fri Jan 26 13:26:30 EST 2007 | rw
We are developing a new product that requires conformal coating on the motor controller. We selected a silicone based conformal coat due to its ease of use. There has been disagreement among engineers as to its impact on the motor. We have contact
Electronics Forum | Sat Aug 15 07:56:16 EDT 1998 | Clyde F.
| | We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. | Thx for any information | Best Regards, | Stoney Tsai PACE just came out with a new s
Electronics Forum | Tue Aug 11 12:15:34 EDT 1998 | X-man
| | We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. | Thx for any information | Best Regards, | Stoney Tsai Stoney, Probably the best rewor
