Electronics Forum | Mon Oct 24 16:24:53 EDT 2011 | smdbert
Hello, My name is Bert i'm working by LéTÉ with two mydata smd machines and have sometimes several problems ,most of the problems try to solve it by myself but sometimes the boss also helps and i write the errors in map but first of all 4 questions
Electronics Forum | Wed Oct 26 11:02:41 EDT 2011 | dyoungquist
TP9 machines are good, but old machines. We ran a TP9 for many years. As the machine got older it required more and more maintenance and had more frequent small issues similar to what you are seeing. We only saw 1 of your 4 issues specifically whi
Electronics Forum | Mon Jan 15 09:19:29 EST 2007 | tk380514
We use Alpha EF-2202 low-VOC No-Clean flux Selective wave soldering cassettes Bottom pre-heating wave soldering machine We have one component that will not solder properly: http://www.epcos.com/web/generator/Web/Sections/ProductCatalog/Capacitors/Ul
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Fri May 22 16:35:21 EDT 2020 | gabriel1blue
Thank you! I think the rotary counter motor went out or the belt broke? The left side is moving fine the right doesn't move at all. If I push the right side very close to origin point some times the machine will complete the process. I'll check that
Electronics Forum | Wed Apr 21 14:32:52 EDT 2010 | remullis
These ovens maintain good profiling as long as you stay on top of maintenance. I had 4 150's and 1 125. The biggest headache is keep the plenums cleaned (very messy). Also the blower motors have been replaced a few times on them as well. If I were yo
Electronics Forum | Wed Jan 31 17:01:34 EST 2007 | rw
I'm not that concerned about the solderability of the motor. Our customer is concerned about the outgassing of the conformal coat effecting the motor brushes. Silicone will break down into SiO2 and SiC will result from a spark between the brushes a
Electronics Forum | Wed May 25 17:58:07 EDT 2011 | rssimmons
The SimmScope is a first article inspection system that uses an overhead digital microsope on a motorized gantry to inspect the board - much like an AOI - except that it does not automatically make the pass/fail decisions. It is up to the operator to
Electronics Forum | Thu Jun 01 11:17:05 EDT 2006 | Dr.Lou
I ended up buying the Assembleon. MyData was the only other brand in the Northwest with enough of a presence to consider. The MyData salesman sank his own ship by being too aggressive, and his quote dropped 45% in one week when he found out we were l
Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e