Electronics Forum | Wed Jul 15 06:32:03 EDT 1998 | Process Engineer
| We just have a use cp4 .I have a problem on transfering data between cp3 to cp4 .when I use the data for cp4 I can't have parts in correct location. Is that normal? or it's because that has a different vision system.if so.how can i do with it.the d
Electronics Forum | Mon May 01 10:26:14 EDT 2000 | Mike Naddra
I Have approximately 150-200 Fuji Cp4-3 8x4mm 1.0 TLC, LARGE Tail feeders. I am looking for an even trade for Fuji Cp4-3 8x4mm 1.0 TLC, SMALL Tail Feeders. If anyone is interested Please respond. Thanks, Mike Naddra
Electronics Forum | Thu Sep 10 09:21:27 EDT 1998 | Y.F. Michael Kou
| We are using PCBs of CEM3 Material with bare copper fiducials. The whole | board is of bare copper with a lacquer coating (Coats brother S2974). | The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as | well as Fuji CP4-3. In bo
Electronics Forum | Thu Dec 09 13:22:24 EST 2010 | rodrigo
Hi All, I'm trying to use the F4G CP-4 optimizer. I cleared all the issues I was having except for this error I get at the end: Execute, 2030: Cycle Time table file not found I see a file in one of the folders named CP4_CYC.TBL but I'm not sure if
Electronics Forum | Wed Nov 24 07:02:15 EST 1999 | JAX
Larry, Carl's right about vision 254 and 255 but I believe CP4's can be set up to check for a part on the nozzle,(parts check sensor)like any other CP. This could be activated to make sure parts are being placed. Then again CP4's might not ha
Electronics Forum | Thu Jun 29 09:13:02 EDT 2006 | MarkM.
I am looking for bulk of parts for a CP4/CP43. If you are sitting on those old CP4 parts and tired of wiping the dust off please let me know so we can discuss so I may get them from you. Also listed this in marketplace already as well. mmjm_1099@ya
Electronics Forum | Thu Jun 10 10:44:34 EDT 1999 | John Eramo
CP4-3 AND IP3 >CP4-3 AND IP2 >CP4-3 AND IP3 >CP4-3 AND IP2 >CP3 AND IP2 >CP3 AND IP2 Question: Looking for anyone who has this type of mix, equipment and what is your OEE and how do you come up with the numbers. I use Unicam Line monitor system to c
Electronics Forum | Tue Jul 10 08:59:07 EDT 2012 | zrunkle_api
First post here. the company I work for has to CP4 and the newer of the two is given us a Q4 Rotation Error. Anyone have any idea what this is and what is causing it?
Electronics Forum | Tue Jan 14 15:38:28 EST 2003 | fujispares
Hi, CP3 will have trouble placing 0603 parts - I wouldn`t use a CP3 for these parts - A CP4 will be more suitable. A older CP4 feeder will fit and function on a CP3.
Electronics Forum | Fri May 23 07:07:39 EDT 2003 | qp1
Please your comments for placing 0402 on CP4? Which are the difficulties to expect and how to threat them? How to adapt the feeders for the smaller interdistance of the tape?? Thanks