Electronics Forum | Mon Jun 12 17:32:17 EDT 2006 | flipit
Hi, A little off subject but I just finished a quick little experiment where I placed 0201 to 1206 and some ceramic resonators at specific distances off the scored edge. The distances from scored edge ranged from 0.025" on up at 0.025" increments.
Electronics Forum | Thu May 25 18:58:49 EDT 2000 | Mukesh Lad
We are a tape and reel house,we use a variety of machines. If you are looking for low voulume, low cost and easy set up for you operators. I would look at Systemation MT-30, this is a good work-horse, I have used them for 10years for small runs, no
Electronics Forum | Wed Jun 14 10:12:33 EDT 2006 | Board House
Hi all, The majority of score machines used today have a top cutting wheel and bottom cutting wheel. This way they can score a line in one pass and saves on programming time, Panels are typically scored in one direction first and then the panel is r
Electronics Forum | Mon May 04 16:34:13 EDT 1998 | Denis Desrochers, Manufacturing Engineer
We are just starting out with SMT. I need any and all the information you have. We are looking to start a small to mid range line.
Electronics Forum | Fri May 28 12:03:07 EDT 1999 | Tom O.
Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill? Is
Electronics Forum | Mon Jul 20 10:23:29 EDT 1998 | Sherry
Hello friends.... Can someone please point me in the right direction... I will be needing the capability of forming/trimming QFP's on a very low volumn scale in house. So far I've only been able to find one manufacturer and that is Fancort Industri
Electronics Forum | Mon Jul 20 13:28:14 EDT 1998 | Chris Fontaine
We regularly form QFP's and FP's (pitches to 20 mil) and have experience with both Knight and Fancort equipment, however most of our experience has been with Knight. Knight Tool has been consistently good, and I've had some sour experiences with Fan
Electronics Forum | Fri May 28 15:01:02 EDT 1999 | Tony
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Fri May 28 16:03:10 EDT 1999 | Jeff Sanchez
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Sat Oct 10 08:12:50 EDT 1998 | Rick I.
we currently have a siplace line(80s/f) and are inhereting a fuji line from another site. I need an objective comparison between the two. What are the strengths and weaknesses of the fuji with regard to programming, operating and maintenance. any cav
World Equipment Source has over 20 years experience in Electronic Assembly Equipment. We will resell your equipment by utilizing our global market of associates.
Equipment Dealer / Broker / Auctions
8655 Production Ave Suite B
San Diego, CA USA
Phone: 858-693-1991