Electronics Forum | Wed Jun 29 15:42:19 EDT 2011 | dekhead
Yes it is "Print Front Limit" and "Print Rear Limit". Negative value extends the stroke, Depends on software version how useful it will be, as there are differing limits on how much you can extend the stroke. http://www.dekhead.com
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Fri Jun 22 20:46:10 EDT 2007 | nickh
I ran into an error with our DEK 288 machine, when I go to initialize the machine the following error occurs: Squeegee Height: Error Input Active. This occurs with or without a squeegee present, and I have tried restarting multiple times, but the sa
Electronics Forum | Tue Jun 26 11:18:41 EDT 2007 | ck_the_flip
But DEK's are the best printers out there!
Electronics Forum | Thu Aug 27 03:19:21 EDT 2020 | dekhead
Have you done Squeegee Heights calibration? (no tools required) Does it complete cal routine without error? Does pressure compensate on next print, with corresponding squeegee, following acknowledgement of pressure error? The readings calibration, ge
Electronics Forum | Tue Jun 26 10:53:25 EDT 2007 | chrisgriffin
Have no idea what that is, but I have a 288 here. Wanna buy it?
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
