Electronics Forum | Thu Feb 22 07:03:12 EST 2001 | davef
I guess the answer to that would have something to do with the distribution of the problems across the various components on the board. [I hear you saying that it's isolated to a specific component, from a specific supplier; rather than being more l
Electronics Forum | Tue Dec 18 11:18:51 EST 2001 | SMTnet
SMTnet welcomes Aqueous Technologies to our group of Distributed Forum participants. Aqueous Technologies has been an avid participant in the forum and we thank them for their support. To see the forum on the Aqueous Technologies site, please go to
Electronics Forum | Thu Apr 01 03:22:59 EST 2004 | paul pmd
Deltawave flux pump continously runs while in run mode. After the pump there is a flux manifold distribution block. When switching between fluxes not all previous flux is purged or drained. When no clean is installed some cross contamination may occu
Electronics Forum | Thu Sep 03 01:14:40 EDT 2009 | sachu_70
Yes, it is important to ensure blade pressure over stencil is uniformly distributed across the entire length of blade. Such is possible only if the stencil is firmly supported from below, which during printing is done by the presence of the PCB itsel
Electronics Forum | Tue Sep 21 09:49:50 EDT 2004 | Pomponio Magnus
Has anyone ever seen the distributions that result when plotting percent voiding? (Typically a BGA will have enough balls that you can get oogles of data.) I have seen this and seem to be noticing a pattern. First, they are not all normal, so your
Electronics Forum | Wed Sep 29 14:45:11 EDT 1999 | Earl Moon
| Hello all, | | There was a problem with the web email system, and it has not been distributing emails properly since Sept 25. It is now fixed, and the awaiting emails have been distributed. | | Sorry for the inconvenience, | Cliff | Cliff, Tha
Electronics Forum | Mon Apr 15 21:00:57 EDT 2013 | dman97
Hi, I have another problem. This time with a vintage 1995 GSM machine. Upon startup, I am seeing a part to pad LED tower time out. The GSM knowledge base says to change they relay at CR1 on the power distribution board. On this machine, the power
Electronics Forum | Thu Dec 07 09:26:05 EST 2000 | CAL
I do not work for SMTNET but this has been my experience from the past.........www.driveway.com is a site that you can up load images to and distribute the web address for all to veiw. Hope this helps Cal
Electronics Forum | Sun Oct 08 20:46:52 EDT 2000 | Roland
Thanks to all for your input! By distributing literature at the show we hoped to increase the membership of your community and bring in as many electronics manufacturing professionals as possible to mutually benefit through information sharing. Any
Electronics Forum | Thu Aug 17 07:48:46 EDT 2000 | Kamran.T
Sounds like improper heat distribution! Raise your prheat/soak time to assure even heating of the board∂. Another issue could be the moisture causing this anomaly.
