Electronics Forum | Thu Oct 21 11:32:15 EDT 1999 | John Thorup
Larry Elaborating on the specific question, yes, the volatile solvents in the flux can and will evaporate. Evaporate completely in any reasonable amount of time? Probably not. What tends to happen is that the exposed paste dries on the surface and
Electronics Forum | Mon Nov 09 08:50:08 EST 1998 | Larry Johnson
Here is a good one for ya. Our IP3's MTU will not pick QFP240's out of cavities, 10, 12, 13, 15. This is a 3X8 tray. The listed cavities are also the closed cavities that are used for tray eject. There is plenty of vaccum, the nozzle comes down f
Electronics Forum | Sun Aug 02 21:59:37 EDT 2009 | hohk
Wow! Thanks Jim!. When the ejector pin hits the piezo ceramic sensor, the sensor will produce a voltage difference between the top and bottom surface(that's why i need to connect the tracks on both sides) which i will measure. The sensor does not ne
Electronics Forum | Mon Nov 13 14:58:56 EST 2017 | davef
Determine the origin of the solder * Sloppy paste printing technique * Lax stencil underside cleaning practices * Sloppy misprint cleaning practices * Poor part placement practices creating solder balls * Poor material control allowing solder p
Electronics Forum | Tue Dec 05 20:55:35 EST 2017 | tristanl
Hi all, We traded our 4c work holder for a transport with another company. Eventing works, except that when I put a board in it does not index. All the other functionality seems ok. The rail width moves, I can eject the board, and it knows it needs
Electronics Forum | Tue Nov 10 12:06:59 EST 1998 | Steve Herring
Larry, We place QFP240's all the time with our 2 IP-3's. If you provide your e-mail or fax number, I can send you the PD that we use for our QFP's. Steve | Here is a good one for ya. Our IP3's MTU will not pick QFP240's out of cavities, 10, 12,
Electronics Forum | Thu Nov 12 18:08:38 EST 1998 | Steve Abrahamson
Larry, We once had a problem in which the IPIII would pick on one area of the tray and not on another. It turned out to be the vacuum hose. There was a small crack/cut in the hose, and when the robot (and attached hose) was in a particular positio
Electronics Forum | Thu Nov 12 18:39:10 EST 1998 | Phillipf fHunter
| Here is a good one for ya. Our IP3's MTU will not pick QFP240's out of cavities, 10, 12, 13, 15. This is a 3X8 tray. The listed cavities are also the closed cavities that are used for tray eject. There is plenty of vaccum, the nozzle comes down
Electronics Forum | Fri Sep 07 14:51:36 EDT 2001 | Claude Couture
What kind/brand of machine are we talking about? Are the missing parts randomly distributed or are specific to a feeder/placement/pattern? Does your machine remember where to resume placement if you reset it in the middle of a pattern placement? We h
Electronics Forum | Fri Feb 17 12:53:30 EST 2006 | bvdb
We just got our used Fuji IP-1 working well. Sometimes during testing of a new program/pcb we like to stop the run and re-start with a clean board. When we make the IP-1 eject the unfinished pcb and start with a new pcb the IP-1 does not scan the f